1) solid fraction
凝固分数
1.
The relationship of local solid fraction with temperature in the mushy layer was tentatively obtained by .
两相区凝固过程中,先期潜热释放总量大,总凝固分数大,两相区厚度迅速增长;随后总凝固分数随相界面迅速上移而急剧下降,经历准稳态过程后再缓慢上升。
3) solidification coefficient
凝固系数
1.
Byanalyzing and measuring the breakout shell and the actual conditions of the billets in the large scale production ,the thickness and solidification coefficient of the solidified shell of the billet are calculated and law of 165×165 mm billet shell growth and its non uniformity revealed.
通过分析、测定拉漏坯壳和大生产中铸坯的情况,计算出连铸小方坯凝固坯壳的厚度及凝固系数,揭示了165mm×165mm小方坯连铸坯壳的生长规律和不均匀性,指出坯壳生长的不均匀性是造成连铸小方坯变形和角裂漏钢的前提条件,并为评价二冷系统的冷却能力、制定合理的二冷配水制度和高拉速条件下的工艺参数提供了重要依据。
2.
In this paper,the author calculates the solidification coefficient of billet in the case of high speed,It has a practical significance to direct the selection of technological parameters of continuous casting.
计算了高拉速条件下的铸坯凝固系数 ,对于指导高效连铸工艺参数的选择有实际的意义 ,指出由于过热度的存在 ,坯壳的生长不完全服从抛物线规律及高拉速下 ,结晶体内铸坯的凝固系数较高 ,而综合凝固系数变化不
3.
The solidified shell thickness and solidification coefficient of slab in the secondary cooling zone on Pangang curved slab caster have been studied,by use of “pin shoot”method.
研究工作运用“射钉法”,准确地标定了攀钢弧形板坯连铸机二冷区凝固坯壳厚度及凝固系数 ,为评价现有二冷系统的冷却能力、制定合理的二冷配水制度和高拉速条件下的工艺参数提供了重要依据。
5) Freezing_derivative
凝固导数
6) molecular depression constant
分子(凝固点)降低常数
补充资料：连分数的渐近分数
连分数的渐近分数
convergent of a continued fraction
连分数的渐近分数l阴ve吧e时ofa阴‘毗d五，比.;n侧卫xp口.坦”八卯6‘] 见连分数(con tinued fraction).
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条