1)  leakage rate
漏液率
1.
2% respectively,the leakage rates of LR6 batteries stored at 70 ℃ for 80 d and at normal temperature for 30 d could be decreased to 8.
2%;同时可使LR6电池高温(70℃,80 d)和常温贮存(30 d)漏液率,分别降低到8。
2)  weeping
漏液
1.
In a 600 mm diameter column, hydromechanics of CTST-8 including pressure drop, entrainment and weeping liquid was studied.
在直径600mm的实验塔上对CTST-8的塔板压降、雾沫夹带、漏液等流体力学性能进行了实验。
2.
Pressure drop,weeping and entrainment of serrated valve tray were measured and compared with those of F1 valve tray.
在直径600mm的有机玻璃塔内,以空气-水为实验物系,对齿边浮阀塔板的流体力学性能进行研究,测定了塔板压降、漏液、雾沫夹带等性能参数,并与F1型浮阀塔板作对比。
3.
Reasonable structure of the tray was achieved relying on measuring its important (hydrodynamic) features such as pressure drop between trays,weeping,entrainment etc.
在600mm的有机玻璃冷模塔中,用水-空气体系测定矩形垂直筛板的塔板压降、漏液和雾沫夹带等流体力学性能,确定了合理的塔板结构,使其具有较高的气液通量和较宽的操作范围,空塔动能因子最大可达3。
3)  leakage
漏液
1.
Measures to resolving the leakage of iron can GN100 battery;
解决铁壳GN100电池漏液的措施
2.
Analysis of leakage reason for alkaline Zn-MnO_2 battery;
碱性锌锰电池漏液原因分析
3.
Research of leakage cause of VRLA battery;
阀控式密封铅酸蓄电池漏液原因初探
4)  Liquid leakage
漏液
1.
The reasons of local liquid leakage and difficulty in overhauling of the dead trays in rectifying tower kettle for butadiene extraction were analyzed and the coupling and sealing structure of dead trays were redesigned.
分析了造成丁二烯萃取精馏塔塔釜死塔盘局部漏液和检修拆装困难的主要原因，重新设计出由卡板、螺栓和聚四氟乙烯混编盘根组成的死塔盘的联接与密封结构。
5)  leakage liquid
渗漏液
1.
Study on recovering copper from copper mine underground leaching leakage liquid;
从铜矿山地下溶浸渗漏液中回收铜的研究
6)  plugging fluid
堵漏液
参考词条
补充资料：漏液
分子式：
CAS号：

性质：筛板塔中气液两相接触过程当气速较小时，部分液体从筛孔直接落下的现象。严重的漏液会使筛板上不能积液而不能正常操作。要避免漏液，必须使气体分布均匀，使每个筛孔都有气体通过。为使气体分布均匀，应使筛板结构设计合理，并避免气速过小。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。