1) H2S concentration
H2S含量
1.
On the basis of high-pressure and high-temperature experiment of H2S solubility in water and material balance analysis,a forecast model for the variation of H2S concentration was established.
对流体相平衡及高温高压下H2S气体在水中溶解度的实验研究表明,在高含硫气田开发过程中,H2S含量增加缘于原始地层水中所溶解的H2S气体在地层压力降低后部分脱附而进入地层气相中。
2) well with H2S content
含H2S气井
3) Gas field containing H 2S
含H2S气田
4) Oil And Gas Field Containing Hydrogen Sulfide
含H2S油气田
5) H_2S
H2S
1.
The cell was used to investigate the electrochemical corrosion behavior of 16Mn steel coated with a thin electrolyte layer containing H_2S and compared with that in bulk aqueous solution of H_2S, making use of polarization curve technique and electrochemical impedance spectroscopy (EIS).
利用自行设计的测量金属在薄层液膜下腐蚀的三电极电化学电池,通过极化曲线和交流阻抗技术(EIS)研究了16Mn钢在含H2S薄层液膜下的电化学行为,并与之在大量H2S电解质溶液中的电化学行为进行了比较。
2.
The influences of the acidity of solution,temperature,immersion time and polarization potentials on corrosion behavior of X70 steel in weak acidic solutions with H_2S were studied by means of potentiodynamic polarization curves and electrochemical impendence spectroscopy.
用动电位扫描法和电化学阻抗谱研究了X70钢在含H2S弱酸性溶液中的腐蚀行为,讨论了酸度、温度、浸泡时间、极化电位对X70钢腐蚀行为的影响。
3.
A new technology of removing H_2S with solution containing Cu~(2+) was developed in this thesis,CuS produced was oxidized by superfluous Cu~(2+) and Cu~(2+) can be recovered from the oxidation reaction of CuCl~-_2 with air,then the circulation was totally realized.
开发了一种用含Cu2+的溶液吸收H2S,并用Cu2+自氧化CuS制取硫磺的新工艺,Cu2+的还原产物CuC l2-由空气氧化再生,实现循环。
6) hydrogen sulfide
H2S
1.
To compare the ability of AC,IACⅠand IACⅡfor removal of hydrogen sulfide,the breakthrough curves for removal of low concentration H2S on fixed bed were measured.
通过测定低质量浓度H2S在固定床上的穿透曲线,比较了原活性炭(AC)、IACⅠ和IACⅡ的脱硫效果。
2.
The operation results for sixty days show that the concentrations of hydrogen sulfide and ammonia in the outflow are ranged from 0.
60 d的除臭运行结果表明,在H2S和NH3的进气浓度分别为0。
3.
Laboratory studies of SQ105 deep desulfurization catalyst for removal of hydrogen sulfide,carbonyl sulfide and mercaptan at ambient temperature were described.
介绍了SQ105型脱硫剂常温脱除H2S、COS和CH3SH的实验室研究以及在不同气体中脱除COS的性能。
补充资料：《纺织品纤维含量的标识》(FZ／T01053—1998)
《纺织品纤维含量的标识》(FZ／T01053—1998)
Textiles-Designation of Fibre Content
FangZhiPin Xian明1 Honliong de BiaOZhi《纺织品纤维含t的标识》(万刀T 01053一1998)(爪荡￡幼郎.加匆刁以勿nof踢。。几饱瓜)纤维种类及其含量是纺织品品质标志的重要内容之一。根据纺织制品形式和结构，提出了标注纤维含t的具体要求，解决了不同产品标识的统一问题，如带里料的产品应对里和面分别标注;带填充物的产品应把填充物和套分别标注;二种以上的不同织物拼接或镶嵌的产品应分别标注不同织物;只起装饰作用而不作为产品主体的可以不标。规定统一采用国家标准规定的纤维名称，避免了任意标注商品名称、外来语名称等造成的纤维名称混乱问题;规定了以成品中某种纤维的量占纤维总量的百分数表示，而不以生产实际的投料比例标注，解决了纤维含t概念(即基数不清)的问题。明确规定了各种纺织品的纤维含量允差，既与原有的纺织品标准衔接，又明确了各种单一纤维纯纺、二组分或多组分纤维混纺或交织产品的明示含t值与实际值可允许的差值，使标准具有可操作性，解决了含t偏差判定的根本问题，使市场抽查有据可依。对统一纤维成分及其含量的标识起到了积极的指导作用，对保护消费者的利益，维护生产者的合法权益有着重要意义。(郑宇英)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条