1) rehydration degree
再水化程度
1.
The samples with different content of dehydrated phase of hydrated cement paste were prepared to study the influence of heat treatment on their rehydration abilities which were evaluated with the water requirements for normal consistency,the initial setting time,rehydration degree and compressive strength.
试验表明:在一定温度下,随着脱水相含量的增大,脱水水泥石粉的标准稠度用水量显著增大,初凝时间逐渐缩短,再水化程度发展加快,抗压强度逐渐减小,即热处理后旧水泥石中脱水相的含量影响其再水化性能。
2.
5) subjected to high temperatures were evaluated by the water requirements of standard consistency,the setting times,the compressive strength,rehydration degree and mineral analysis by XRD.
结果表明:随着处理温度的提高,旧水泥浆的标准稠度需水量显著增大,初、终时间逐渐缩短,抗压强度呈上升趋势,在800℃左右达到最大值;热处理后旧水泥浆的再水化程度发展很快,1 d水化程度达到60%,28d水化程度接近90%。
2) hydration degree
水化程度
1.
Effect of water-binder ratio and composition on the hydration products and hydration degree of complex shrinkage-compensating binders;
水胶比和组成对补偿收缩胶凝材料水化程度与水化产物的影响
2.
The effects of mineral materials, grinded blast furnace slag (S), high-calcium fly ash (HF), desulfurized gypsum (DG), calcined desulfurized gypsum (CG) and sodium sulfate (NS) on the hydration degree of cement pastes are researched according to testing results of the chemical shrinkage, the hydration heat and the compressive strength.
结果表明:采用20%高钙灰替代矿渣粉对早期水化程度和初始结构建立影响不大,脱硫石膏或煅烧脱硫石膏作激发材料能够分散早期的集中放热而对总体水化进程影响不大;水化热对水化过程的反映比化学收缩更清晰和更准确。
3.
In this paper, the modeling and simulation process of CEMHYD3D is analyzed, the hydration process of CCRL Cement 133 at different water-to-cement ratios is simulated with CEMHYD3D, and several properties, such as the hydration heat, the hydration degree, the variation of the reactant and the product are predicted.
分析了水泥水化过程计算机模拟这一领域最有代表性的模拟系统——CEMHYD3D的建模过程,以CCRLCement133水泥为例,对不同水灰比条件下的水泥水化过程进行了实际模拟计算,对水化热、水化程度、水化过程中主要反应物和产物的变化情况进行了预测。
3) degree of hydration
水化程度
1.
In pozzolanic effect, the degree of hydration was calculated according to the hydration model and the measured parti.
利用水化程度与颗粒粒径、水化深度的理论关系 ,结合矿渣粉体实测的粒径分布 ,计算了超细粉的水化程度 。
2.
A computer simulation-based method is presented for predicting the degree of hydration.
总结了水泥水化计算机模拟的基本原理,强调了水泥颗粒之间的干扰效应,基于计算机模拟所得的水泥石微观结构,提出了水泥水化程度预测方法。
4) high hydration degree
高水化程度
5) reprogramming
再程序化
1.
The key to make a break-through in the research of cloned animals relies on elucidating mechanism of nuclear reprogramming.
目前动物克隆技术体系极待完善 ,其极低的成功率及克隆动物普遍存在的早衰、早夭现象是阻碍研究深入进行的首要问题 ,其突破的关键在于对核移植后的细胞核再程序化机制的阐明。
2.
By the method of single preimplantation embryos differential display polymerase chain reaction (SPEDDRT PCR),25 reprogramming cDNA fragments were obtained from single 2 cell,8 cell embryos and blastula.
研究家兔移核重构胚再程序化相关基因的表达。
3.
Abnormal expression of developmentally important genes leads to inadequate reprogramming development of NT embryo which subsequently causes failure in animal cloning.
与早期胚胎发育相关的一些重要基因异常表达致使克隆胚细胞核的再程序化过程受阻,是导致动物克隆失败的重要原因。
6) Rehydration
[英][,ri:hai'dreiʃən] [美][,rihaɪ'dreʃən]
再水化
1.
According to the rehydration characteristics of dehydrated phases,a kind of new cementious material system can be prepared with gypsum and fly ash.
根据水泥水化产物脱水相具有再水化能力的特点,结合粉煤灰、磷石膏等矿物材料的化学反应特性,组成一个新的胶凝材料体系。
2.
Ther-mogravimetric–differential scanning calorimeter (TG–DSC), X-ray diffraction, infrared and 29Si nuclear magnetic resonance were used to investigate the structural characteristics, rehydration ability and rehydrating products structure of dehydrated phases prepared at 400, 650 ℃ and 900 ℃.
将水泥石在不同温度进行低温煅烧,得到不同的脱水相物质,通过热重–差示扫描热分析、X射线衍射、红外光谱及29Si核磁共振等对水泥石在400,650℃及900℃的脱水相结构特征及其再水化性能、再水化产物的结构特征进行研究。
补充资料：保险保障程度
保险保障程度
【保险保障程度】企业在风险管理决策，选择保险方式时必须评估的企业的实际财务状况及最大可能损失额。它便于对保险实行不同程度、不同范围的选择。一般可分为必须保险保障、必要保险保障和一般保险保障。 必须保险保障主要是对需要强制保险的项目和预期损失非常严重的标的进行保险。 必要保险保障是对那些可能严重损害企业经营、造成严重的损失后果，但不致于使企业破产或倒闭的损失提供保障。 一般保险保障是为上述两类没有提供的所有种类的可保风险提供保险保障。这类损失不致于给企业带来严重影响，但在一定的程度上给企业生产经营带来不利。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条