After adding an appropriate amount Re and Zr to the CuAlMnZn shape memory alloy,the heat treatment of tested alloy-solution heat treating at 800℃ for 5min,holding at 585℃ for 150min,and water-quenching,the elastic recovery rate of the alloy can be improved obviously.

Preparation of Single Crystal Cu-Al Based Shape Memory Alloy;

Study of the TiNi shape memory alloy prepared through directional solidification;

Transformation characteristics of Ti-50.2Ni shape memory alloy heat-treated in different processes;

Influence of Brazing Temperature on the Properties and Microstructure of TiNi SMA;

Interfacial microstructure of laser-brazed joint between TiNi shape memory alloy and stainless steel;

Surface modification of TiNi shape memory alloy by nitrogen ion implantation;

Simultaneous determination of impurities Co,Cu,Cr,Fe and Nb in TiNi shape memory alloy by ICP-AES;

High-damping capacity of CuAlMn shape memory alloys;

Equal-effective mechanical behavior of Shape Memory Alloys fiber-reinforced composite;

Recovery stress characteristics of TiNi and TiNiCu shape memory alloys;

This paper dealt with the metal inject molding(MIM) of NiTi shape memory alloy(SMA).

This paper introduces the basic characteristic and the constitutive model of Shape Memory Alloy(SMA),then sets up its seismic response motion equation of tall building structures using passive control device and explores its principle and methods of passive control,so we can say that it supplies a new method for vibration control design of tall building structures.

Then,the tip deformation error of the shape memory alloy(SMA) plate pair used as fin actuators is computed theoretically to improve the deformation precision of the SMA biomimetic fish fin.