1) post-casting structure
铸后组织
2) as-cast microstructure
铸态组织
1.
Morphology and Phase Constituent of Secondary Phase in As-cast Microstructure of 7150 Aluminum Alloy;
7150铝合金铸态组织中第二相的形貌及相组成
2.
Effects of Trace Si,Ba and Sn on the As-cast Microstructure of AZ91 Magnesium Alloy;
微量Si、Ba、Sn对AZ91铸态组织的影响
3.
Effect of lithium on as-cast microstructure of Mg-2Al-1Zn-4Y-3Nd alloy;
Li含量对Mg-2Al-1Zn-4Y-3Nd合金铸态组织的影响
3) As-cast structure
铸态组织
1.
On the basis of twin-roll thin strip continuous casting experiments, structure and composition analysis, the as-cast structure characteristics of 1Cr18Ni9Ti stainless steel twin-roll thin strip were investigated.
通过双辊薄带连铸试验和组织成分分析,对1Cr18Ni9Ti不锈钢双辊薄带的铸态组织特征进行了研究。
2.
The effect of yttrium on as-cast structure and age hardening of the magnesium alloy Mg-9Al-1Zn were investigated.
研究了稀土元素钇 (Y)对Mg 9Al 1Zn合金铸态组织及时效硬化特性的影响。
3.
The investigation was carried out experimentally on as-cast structure evolution of horizontal continuous casting aluminum alloy under combination electromagnetic field.
采用试验的方法研究了组合磁场作用下5182铝合金水平连铸过程中铸态组织的演变。
4) cast microstructure
铸态组织
1.
Effect of N on in-cast microstructure and mechanical properties of Ti-6Al alloys;
氮对Ti-6Al合金的铸态组织与性能的影响
2.
As-cast microstructure and mechanical properties of Ti-N alloys;
钛氮合金的铸态组织与性能
5) cast structure
铸态组织
1.
The cast structures and component of vacuum melten and rapid solidified Cu-15Ni-8Sn alloys without Si or with different addition levels of Si (0.
2%)的Cu-15Ni-8Sn合金的铸态组织形貌及构成进行了研究。
2.
The cast structure and component segregation were studied in Cu 15Ni 8Sn with addition of Si by optical microscope, SEM and energy spectrum analysis.
用金相、扫描电镜及电子能谱微区成分分析等方法对添加少量Si的Cu 15Ni 8Sn合金的铸态组织结构及成分偏析进行了研究。
3.
50 %, mass %) of mischmetal on cast structure and hardness of Al 7Si 4Cu alloy is studied by using metallographic analysis,electronmicroscope and thermal analysis.
５０％，质量分数）对Ａｌ－７Ｓｉ－４Ｃｕ合金铸态组织与硬度的影响。
补充资料：衡阳钢管厂水平连铸机生产连铸圆管坯
衡阳钢管厂水平连铸机生产连铸圆管坯
衡阳钢管厂水平连铸机生产连铸圆管坯
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条