Effect of hot working on strength and toughness of hot-rolled steel containing copper;

The effect of annealing on microstructure and high temperature erosion property of arc-spraying coatings containing nanosized ceramic powders;

Effect of annealing on the oxidation behavior of peened 1Cr18Ni9Ti alloy;

Effect of Annealing on the Magnetism of Sintered NdFeB Magnets;

The effect of quenching treatment on the microstructure and abrasive wear resistance of in situ TiC p/Fe composites has been investigated.

The thermal expansion coefficients of Cu-Al alloy at 25～700 ℃ were measured by thermal dilatometer, and the effects of quenching treatment on thermal expansion characteristics of Cu-Al alloy were studied.

Remedy of unqualified high strength hot rolled steel strip by tempering treatment;

The measurement shows that the compressive residual stress of the laser multiple processed K24 superalloy surface exceeds 600 MPa,and after 8 and 16 h tempering treatment at 500 ℃,the residual stresses still exceed the average residual stress of the K24 base body,showing a good stability against the tempering,which is of help to improvement of the fatigue li.

A tempering treatment for 2 h at 800-1080℃ has been carried out in an argon atmosphere.

Effect of annealing treatment on microstructure and properties of as-cast austenitic-bainite nodular iron by permanent mold casting;

Influence of annealing treatment on microstructure and properties of AZ31 magnesium alloy sheet processed by equal channel angular rolling;

Effects of annealing treatment on electrochemical properties of Re_(0.92)Mg_(0.08)Ni_(2.81)Mn_(0.10)Co_(0.51)Al_(0.11) alloy electrodes;