1) Al-4.5%Cu alloy
Al-4.5%Cu合金
1.
Relationship between primary dendrite arm spacing of Al-4.5%Cu alloy and withdrawal rate during unidirectional solidification;
定向凝固Al-4.5%Cu合金枝晶组织与抽拉速率的关系
2) Zn-4.5%Al Alloy
Zn-4.5%Al合金
1.
Effects of RE,Mg and Ti on the Corrosion Resistance of Zn-4.5%Al Alloy;
RE、Mg及Ti对Zn-4.5%Al合金耐蚀性的影响
3) in-situ composites of TiCp/Al-4.5%Cu
TiCp/Al-4.5%Cu原位复合材料
4) Cu-Al alloy
Cu-Al合金
1.
Identification of the oxide layer of Cu-Al alloy plate produced by internal oxidation;
Cu-Al合金平板试样内氧化层的测定
2.
3% com-pared with unsintered blank at the same time,and internal oxidation of Cu-Al alloy particles ocnurs.
3%;同时Cu-Al合金颗粒完成了内氧化,生成了大量粒状的Al2O3并弥散分布于铜基体,其粒径约为5~20 nm,颗粒间距约为25~60 nm。
3.
Thermodynamic requirements of internal oxidation of Cu-Al alloy were systematically analyzed, and the area chart of internal oxidation thermodynamics was drawn at the same time.
对Cu-Al合金内氧化的热力学条件进行了分析,绘制了内氧化的热力学条件区位图。
5) Al-Cu alloy
Al-Cu合金
1.
Effect of Al-Cu alloys diameter on thermal gradient and primary dendrite arm spacing during directional solidification;
试样直径对Al-Cu合金定向凝固温度梯度和一次枝晶间距的影响
2.
Effects of Rectangle Wave Pulse Current on Solidification Structure of Al-Cu Alloy;
方波脉冲电流对Al-Cu合金凝固组织的影响
3.
Effect of aging treatment on microstructure and properties of lead-free free-cutting Al-Cu alloy;
时效对无铅易切削Al-Cu合金的微观组织结构与性能的影响
6) Al-Cu alloys
Al-Cu合金
1.
The α-Al and the Al_2Cu's growth action and the ability of the eutectic nucleus formation of the primary crystal phase α-Al and Al_2Cu in Al-Cu alloys were investigated by means of Scanning Electron Microscope and X-Ray Diffraction.
研究了Al-Cu合金中-αAl和Al2Cu的生长行为,分析了初生-αAl及初生Al2Cu作为共晶核心形核的能力。
2.
Eutectic transformation point of Al-Cu alloys solidified under 5 GPa pressure condition had been determined through the microstructures study.
通过对Al-25%Cu和Al-45%Cu合金在5 GPa压力条件下组织凝固的研究,测得了Al-Cu合金在5 GPa压力条件下的共晶点,结合H。
3.
Firstly, primary dendritic spacing under unidirectional solidification of Al-Cu alloys is studied by changing the quantity of copper and adding different compound RE .
本文使用5kg坩埚下拉式定向凝固炉，对Al-Cu合金进行了大量的定向凝固试验。
补充资料：pyridaphenthion-trichlorphon powder,4.5%
分子式：
分子量：
CAS号：
性质：简称4.5%哒敌粉。一种有机磷杀虫剂混合制剂。按照筛选出的最佳配方，将哒嗪硫磷与敌百虫原药、填料、稳定剂等，经过混合、粉碎而制成。外观为松散的易流动粉末，颜色视填料种类不同而异，细度为95%通过200目筛，遇热不稳定，碱性条件下易分解。对人畜毒性低。可直接作喷粉施用。主要用于防治水稻二化螟、三化螟、大螟、稻纵卷叶螟、稻苞虫、叶蝉、飞虱、蓟马、小麦粘虫、麦红蜘蛛等害虫。
分子量：
CAS号：
性质：简称4.5%哒敌粉。一种有机磷杀虫剂混合制剂。按照筛选出的最佳配方，将哒嗪硫磷与敌百虫原药、填料、稳定剂等，经过混合、粉碎而制成。外观为松散的易流动粉末，颜色视填料种类不同而异，细度为95%通过200目筛，遇热不稳定，碱性条件下易分解。对人畜毒性低。可直接作喷粉施用。主要用于防治水稻二化螟、三化螟、大螟、稻纵卷叶螟、稻苞虫、叶蝉、飞虱、蓟马、小麦粘虫、麦红蜘蛛等害虫。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条