1) transverse cracking
横向开裂
1.
Sensitivity analysis of transverse cracking for continuously reinforced concrete pavement;
连续配筋混凝土路面横向开裂的敏感性分析
2.
Development laws of transverse cracking for continuously reinforced concrete pavement;
连续配筋混凝土路面横向开裂发展规律
3.
Talreja for study of transverse cracking in composite materials, a more reasonable method for calculation of the restricted coefficients is introduced, and used for study of transverse cracking in composite laminated plates.
在Talreja提出的研究复合材料横向开裂的损伤力学方法的基础上,文中引进了一种更合理的计算约束系数的方法,并将其用于研究复合材料叠层板的横向开裂,预估了其弹性模量的变化。
2) transverse crack
横向开裂
1.
This article briefly introduces production process flow and its main equipments of seamless ERW pipe of 20 steel,and analyzes cause of transverse crack occurred in production of seamless ERW pipe of 20 steel,and gives out the main measures to solve transverse crack.
分析了20钢无缝化ERW焊管在生产过程中产生焊缝横向开裂的原因,提出了解决横向开裂的主要措施。
2.
A numerical iteration method with one-dimension nonlinear mechanical modeling was (created) to analyze the transverse cracking of continuously reinforced concrete pavement subjected to (temperature) and drying shrinkage with consideration of the nonlinear bond slip between steel bar and (concrete) and the (nonlinear) friction slip between concrete slab and subgrade.
考虑钢筋与混凝土之间的非线性粘结滑移关系及混凝土面板与地基之间的非线性摩阻滑移关系,采用数值迭代法建立了连续配筋混凝土路面在温缩和干缩作用下横向开裂的一维非线性力学分析方法,从而同时获得裂缝间距、裂缝宽度与钢筋应力3个设计指标的结果,编制了迭代法计算程序CRCPAP。
3) transverse cracking of matrix
基体横向开裂
4) transverse rupture
横向断裂
1.
The structure of transverse ruptured 72A hard steel wire has been observed by microscope and its hardness has been measured.
用金相显微镜和显微硬度计分别观察和测量了拉拔过程中发生横向断裂的 72 A硬线钢组织与硬度。
2.
Fe powder S values of transverse rupture were assayed by technology test.
通过工艺试验测定了Fe粉的横向断裂力值,并应用表示法对所得试验结果进行了对比分析。
3.
The inspection and analysis and the process thermal simulation test have been made by using metallographic microscope and SEM on the failure of transverse rupture in the containing silicon low carbon steel billets after continuous casting.
对含Si低碳钢连铸坯发生的横向断裂缺陷进行了金相、扫描电镜检验分析及加热工艺模拟试验;对铸坯从钢水凝固到轧前加热断裂的热历程中所受外力及其与裂纹形成的关系进行了分析。
5) transverse crack
横向裂纹
1.
Influence of Strength Matchings on the J-Integral ofWelded Joints With Transverse Cracks;
强度组配对含有横向裂纹焊接接头J积分的影响
2.
Study on causes of transverse cracks in main beam of PC cable-stayed bridge from forces analysis;
从受力角度谈PC斜拉桥主梁横向裂纹产生原因
3.
Cause analysis on transverse cracks of water-cooling wall tubes in Ningxia Dawukou Power Plant;
国电宁夏大武口发电厂水冷壁管横向裂纹原因分析
6) transverse cracking
横向裂缝
1.
Centrifugal modeling of transverse cracking in earth core dams;
土石坝横向裂缝的土工离心机模型试验研究
补充资料:穿晶开裂
分子式:
CAS号:
性质:金属材料开裂的金属学特征之一。裂纹由晶粒内部穿过。延性断裂的断口微观特征一般为韧窝状,脆性断裂的特征为解理或准解理花样。
CAS号:
性质:金属材料开裂的金属学特征之一。裂纹由晶粒内部穿过。延性断裂的断口微观特征一般为韧窝状,脆性断裂的特征为解理或准解理花样。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条