1) cracking sensitivity
开裂敏感性
1.
Experimental studies on cementitious systems cracking sensitivity of high performance concrete;
高性能混凝土胶凝材料体系开裂敏感性试验研究
2.
Evaluation of cracking sensitivity of concrete at early age;
混凝土早期开裂敏感性评价
3.
Testing technique of the early performances and the cracking sensitivity of concrete
混凝土早龄期性能与开裂敏感性的测试技术
2) cracking sensibility
开裂敏感性
1.
On the base of orthogonal comparison tests,influences of many kinds of factors on the cracking sensibility of plasma clad coatings have been studied in this paper.
本文采用正交对比试验,研究了多种因素对等离子熔覆铁基涂层开裂敏感性的影响。
2.
The effects of carbon content on the microstructure,cracking sensibility,hardness and hardness uniformity of Fe-Ni-Cr-B-Si alloy powders laser-clad layers was studied.
研究了激光熔覆Fe Ni Cr B Si合金粉末时粉末中的碳含量对于熔覆层组织、开裂敏感性、硬度和硬度均匀性的影响。
3) cracking susceptibility
开裂敏感性
1.
The influence of the content of alloy elements including Ni,Cr and Mo on the hardness,cracking susceptibility and retained austenite of laser-cladding layers on Fe-based alloy was studied, and the reasons resulting in the influencs were explained.
研究了Ni﹑Cr和Mo合金元素含量对铁基合金激光熔覆层硬度﹑开裂敏感性和残余奥氏体含量的影响,解释了造成这些影响的原因。
2.
in the present paper, effects of rare earth content of high temperature cast Ni-based alloy GH33 on the cracking susceptibility of laier melt-casting Co-based alicy coating are studied.
本文研究了高温镍基铸造合金ＨＨ３３上稀土含量对激光表面熔铸钻基合金涂层开裂敏感性的影响。
4) cracking susceptibility
开裂敏感性，裂纹敏感性
5) silique dehiscence susceptibility
角果开裂敏感性
1.
The formation of silique dehsicence susceptibility was investigated in terms of water content, synthetic rate of ethylene, enzyme activity of exo polygalacturonase (PG) and end cellulase , cell alteration in dehiscence zone in silique and silique dehiscence susceptibility during silique development.
从油菜角果发育过程中角果含水量、乙烯合成速率、外切 ＰＧ 酶和内切纤维素酶活性，以及角果裂区切片观察等方面研究了角果开裂敏感性形成的原因⒚花后５０ ｄ 的角果果柄端壳状果瓣和线状果瓣间的裂区薄壁细胞膨大，在高倍光学显微镜下可见胞间空隙开始形成⒚此前６ ｄ 内乙烯合成速率迅速上升并出现第二次合成高峰，与之同步发生外切 ＰＧ酶和内切纤维素酶活性急剧上升，而乙烯合成第二高峰出现于角果含水量低于８０％ 以下⒚由此看来，角果失水引起乙烯合成第二高峰出现，从而导致水解酶活性上升，最终导致果瓣裂区薄壁细胞膨大，分离和胞间空隙形成及角果开裂敏感性产生
6) cracking susceptibility
裂纹敏感性
1.
Current EBW experiments on IC10 guide blade which is being researched in China have shown that the EBW has an obvious cracking susceptibility.
本文介绍了该合金的真空钎焊、TLP扩散焊的研究进展情况,重点分析了我国目前在研的IC10合金导向叶片产生明显电子束焊接裂纹敏感性的原因,并指出了改善电子束焊接工艺参数、填丝合金化和焊后热处理等解决方案。
2.
These help to improve the hot ductility and to alleviate the cracking susceptibility of the slab.
s-1的冷却速度,使铸坯在出结晶器后表面温度下降到A3温度以下,得到的表层组织均匀,晶界无膜状先共析铁素体,微合金元素析出物在晶内分布均匀,有利于提高铸坯热塑性及降低裂纹敏感性。
补充资料：超敏感性疾病
超敏感性疾病
即变应性疾病，指由于超敏感性机制所引起的疾患，如过敏症、血清病、变态反应性皮肤病、某些自身免疫性疾病等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条