1) reheat cracking susceptibility
再热裂纹敏感性
1.
By the same experimental condition,the results show that they have same low cold cracking susceptibility and certain extent reheat cracking susceptibility.
在同等条件下,对这两种钢的焊接冷裂纹和再热裂纹敏感性进行试验,结果表明:其冷裂纹敏感性均较低,但具有一定的再热裂纹敏感性,且前者的再热裂纹敏感性比后者稍低。
2) hot cracking susceptibility
热裂纹敏感性
1.
The influence of Lanthanum, Cerium, Yttrium, Praseodymium and Neodymium on weld hot cracking susceptibility of the pure nickel electrode used for cold welding of cast iron was studied.
研究了纯镍铸铁焊条冷焊时,稀土金属镧、铈、镨、钇及钕对焊缝热裂纹敏感性的影响规律,并分析了铈对焊接接头力学性能和加工性能的影响。
3) cracking susceptibility
裂纹敏感性
1.
Current EBW experiments on IC10 guide blade which is being researched in China have shown that the EBW has an obvious cracking susceptibility.
本文介绍了该合金的真空钎焊、TLP扩散焊的研究进展情况,重点分析了我国目前在研的IC10合金导向叶片产生明显电子束焊接裂纹敏感性的原因,并指出了改善电子束焊接工艺参数、填丝合金化和焊后热处理等解决方案。
2.
These help to improve the hot ductility and to alleviate the cracking susceptibility of the slab.
s-1的冷却速度,使铸坯在出结晶器后表面温度下降到A3温度以下,得到的表层组织均匀,晶界无膜状先共析铁素体,微合金元素析出物在晶内分布均匀,有利于提高铸坯热塑性及降低裂纹敏感性。
4) crack sensitivity
裂纹敏感性
1.
The influences of nickel-based alloys spraying layer on the weld crack sensitivity were studied through simulating actual welding experiment in this paper.
通过模拟实际焊接试验 ,研究了镍基合金喷焊层对焊接裂纹敏感性的影响。
2.
The effects of structure character on the crack sensitivity were analyzed.
利用火焰喷焊技术制备了镍基合金喷焊层,采用光学显微镜和扫描电镜研究了其组织特征,初步分析了该组织特征对喷焊层焊接裂纹敏感性的影响。
5) cracking susceptibility
开裂敏感性，裂纹敏感性
6) cold crack sensitivity
冷裂纹敏感性
1.
50 mm WNQ570 steel,a new type of steel for railway bridge,has been carrying on the experiments of cold crack sensitivity through CJ607Q welding rod and submerged WS03 arc welding wire and SJ101Q welding flux.
采用CJ607Q焊条和WS03埋弧焊丝与SJ101Q焊剂对铁路桥梁用WNQ570钢50 mm厚钢板进行了焊接冷裂纹敏感性试验。
补充资料：热敏感性
热敏感性
①物质对热的敏感性。对敏感者称为不耐热物质，对热不敏感者称耐热物质。②对热的变态反应。接触热(热水浴、热物质等）以后，出现全身性荨麻疹，发热、搔痒、红斑等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条