1) latex coating
乳胶型
1.
A kind of humidity controlling latex coating with diatomite is developed and the moisture equilibrium content and desorption isothermals under different humidity condition of the coatings are obtained.
将硅藻土做成乳胶型涂料,并得到了不同湿度下这种涂料的吸放湿性能曲线,但是吸放湿能力不是很理想。
2) elastomeric latex
弹性乳胶型
3) LIPN
乳胶型互穿网络聚合物
4) latex interpenetrating polymer network
乳胶型互穿网络聚合物（LIPN）
5) emulsion
乳胶
1.
The initiator is summarized in grafting copolymerization preparation emulsion with using starch and ethenyl monomer , each kind of initiator mechanism is commented, influence of the initiator selecting to the emulsion performance is elaborated.
总结了淀粉与乙烯基单体接枝共聚制备乳胶常用的引发剂,对各类引发剂的机理作了评述,讨论引发剂的选用对乳胶性能的影响。
2.
The process of manufacturing emulsion products and its capacity indexes have been analyzed in this paper.
本文分析了乳胶制品的生产过程，并对工序能力指数进行了分析，从而推断出产品的质量。
3.
Methods: A random, single blind, positive-control and multi-center clinical trial recruited 230 patients with osteoarthritis, who were randomly applied onto the affected area with either piroxicam patch (n = 116) once every other day or diclofenac emulsion (n = 114) three times per day for 14 days.
方法:研究采用多中心、随机、单盲、阳性药(双氯芬酸乳胶)平行对照。
6) latexes
乳胶
1.
The results show that the rate of polymerization increases with increasing emulsifier concentration, initiator concentration and temperature, the nucleation period finishes earlier and the particle average diameter of latexes is larger than the particle produced by traditional emulsion polymerization.
对反应性乳化剂作用下的醋酸乙烯酯(VAc)乳液聚合动力学体系进行了研究,实验结果发现,聚合速率随乳化剂、引发剂浓度、温度的增大而加快,乳胶粒平均直径较传统的的乳液聚合乳胶粒子大得多,且成核期结束较早。
参考词条
补充资料：乳胶丝
分子式：
CAS号：
性质：以胶乳为主要原料，用挤出法制得的表面光滑、弹性好的圆形截面线形弹性物。又称乳胶线。主要用于制造弹性织物，如各种松紧口、紧身内衣、游泳衣、袜口等。
CAS号：
性质：以胶乳为主要原料，用挤出法制得的表面光滑、弹性好的圆形截面线形弹性物。又称乳胶线。主要用于制造弹性织物，如各种松紧口、紧身内衣、游泳衣、袜口等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。