说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 高压缸
1)  Hp cylinder
高压缸
1.
The paper analyses the causes of higher vibration of the front radial bearing of CO2 comperessor Hp cylinder and present the corresponding solutions,and then solved the problem .
分析二氧化碳压缩机高压缸前径向瓦振值高的原因,采取相应的措施,较好地解决了该问题。
2.
This paper analyzes and deals with the problem of the trip of CO_2 compressor set caused by high axial vibration of HP cylinder,andproposes the the paecautions against the reoccurrtence of similar incidents.
针对CO_2机组高压缸轴振动高跳车问题进行了分析、判断、处理,提出防止事故再次发生需要采取的措施。
3.
During the performance test implemented after turbine alteration,it is found that the HP cylinder extraction steam tempreture is abnormally high.
在汽轮机改造后的性能试验中,发现高压缸抽汽温度过高,通过分析认为缸内存在漏汽,并指出了漏汽的位置。
2)  high pressure cylinder
高压缸
1.
Temperature and stress analysis for high pressure cylinder of supercritical 1000 MW steam turbine;
超临界1000 MW汽轮机高压缸温度场及应力分析
2.
Analysis of blast fault at the tail of high pressure cylinder in 600 MW turbine and countermeasures
600MW汽轮机高压缸尾部鼓风故障分析及对策
3.
In view of the problems of combustion in the cylinder and flame out of high pressure cylinder, the combus- tion and the causes of problem is analyzed, and the improving measurements are put forward.
针对氧压机缸内燃烧和高压缸喷火的问题,分析了氧压机的燃烧及其原因,提出了分析意见和改进措施,经实践表明,效果良好。
3)  high-pressure cylinder
高压缸
1.
Based on the characteristics of stress distribution in high-pressure cylinder,the formula of calculating the maximal equivalent stress(inside wall) is educed according to the fourth strength theory and the quantitative relationship between cylinder's inside pressure and diametrical ratio and the fatigue limit were founded.
基于高压缸的应力分布特点,由第四强度理论推导出了高压缸最大应力(缸筒内壁处)的当量应力的计算公式,建立了缸筒内压与缸筒径比及持久极限的量化关系。
4)  hi-pressure cylinder casing
高压缸体
1.
Described here in the article is the operating principle of pressing deep blind hole of forged hi-pressure cylinder casing involving the processing method of twice hole-pressing and mould-stripping by "explosion".
介绍了高压缸体锻件冲深盲孔的原理,通过采用两次冲孔和煤粉“爆炸”脱模等方法实现对锻铁深盲孔的加工,此方法简单实用。
5)  super high pressure cylinder
超高压缸
1.
Aim at the problems existed in the super high pressure cylinder in some factory,the super high pressure cylinder is taken the improved design by using the optimal design principle of shrunk-on double-layers cylinder.
然后针对某超高压缸所存在的问题,采用最佳化设计原则对其进行了最佳化设计,求得了最佳径比及有关尺寸。
2.
According to the problems existed in the super high pressure cylinder, an improved design is accomplished.
根据等强度理论所确定的缩套圆筒的界面压力公式及径比条件,对某超高压缸的径比及应力进行了分析计算,发现其径比不符合径比条件,应力分布也很不均匀。
3.
Based on the analysis and calculation of the diametrical ratio and strss to a super high pressure cylinder, it is found that the diametrical ratio doesn t conform to the optimal design principle and the stress isn t well-distributed.
然后对某超高压缸的径比及应力进行了分析计算,发现其径比不符合最佳化设计原则,且应力分布很不均匀。
6)  high and low pressure cylinder
高低压缸
1.
Through a series of technical retrofit such as high and low pressure cylinder of steam turbine, condenser, boiler air pre-heater, low pressure economizer, pump and fan, the power consumption of main equipments and subsidiary motors was decreased.
通过对汽轮机高低压缸通流部分、凝汽器、锅炉空气预热器密封、锅炉尾部加装低压省煤器、泵与风机等一系列技术改造后,主设备能耗和辅机电耗都有明显下降。
补充资料:高压线走廊(高压架空线路走廊)
在计算导线最大风偏和安全距离情况下,35kV及以上高压架空电力线路两边导线向外侧延伸一定距离所形成的两条平行线之间的专用通道。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条