1) cavities
缺陷腔
1.
From the primitive definition of quality factor,a programmable design proposal for photon crystal defect cavities has been obtained,a software based on the three-dimensional finitedifference time-domain method was compiled,and with the aid of this simulation software,the micro cavity quality factors were numerically calculated for both square crystal and the triangle crystal.
从品质因子的原始定义出发,得出了一种可编程的光子晶体缺陷腔品质因子的数值设计方案,基于三维时域有限差分法编写了该方案的计算软件,借助该模拟软件,计算了硅基二维四方晶体和三角晶体微腔的品质因子。
2) single-defect cavity
单缺陷腔
3) point defect micro-cavity
点缺陷腔
4) defects
缺陷
1.
Research on flux mixture defects in ingot of wrought magnesium alloy;
变形镁合金铸锭中熔剂夹渣缺陷的研究
2.
Defects Distribution and Control of Semi-solid Aluminum Alloy (A356) Parts in Thixoforming Process;
A356铝合金半固态触变成形件的缺陷分布及控制
3.
Inspecting defects inside impeller of electric submersible pump by fluid pressure loss measurement method;
流体压力损失法检测电潜泵叶轮缺陷的研究
5) defect
缺陷
1.
The difference and relation between the defect of 1-D photonic crystal and F-P cavity on optical path;
一维光子晶体的缺陷与F-P腔
2.
Analysis of Defects in Friction Stir Welding of Aluminum Alloy;
铝合金搅拌摩擦焊焊接过程缺陷分析
3.
Effect of guiding angle on metal flow and defects in extrusion deformation;
导流角对挤压变形中金属流动与缺陷的影响
6) flaw
缺陷
1.
Test on Repaired Flaw in 12Cr2Ni4 Disk-shaped Forgings;
12Cr2Ni4圆饼锻件内部缺陷的修复试验
2.
A study of triaxial strength and deformation of flawed specimen;
缺陷岩样强度及变形特性的研究
3.
Stress concentration factor and tolerance of flaws on sucker rod wrench square transition area;
抽油杆方凸过渡段缺陷应力集中因数和容限
参考词条
补充资料：点缺陷(见晶体缺陷)
点缺陷(见晶体缺陷)
point defect
点缺陷point defeet见晶体缺陷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。