1) tempercoture checking method
温度校核法
2) control temperature reading
校核温度记录
3) Two-temperature calibration
双温度法校准
4) check for temperature's rise
温升校核
1.
The new method of check for temperature's rise BX1 arc welding transformer is advanced according to principle that the generating and radiating of heat at the arc welding transformer are the same under heat balance condition.
本研究工作根据弧焊变压器在热平衡状态下产热和散热一致的原理 ,提出了BX1型弧焊变压器温升校核的新方法 ,并应用VB 6 0软件开发了BX1型弧焊变压器温升校核的程序 。
5) intensity checking
强度校核
1.
Study on the method of intensity checking of shafts with FEA;
轴系有限元强度校核方法
2.
Based on its static,dynamic analysis and dynamic intensity checking,stress and displacement distribution as well as dynamic response of the whole system and its important components are obtained.
采用ANSYS有限元分析软件对永乐大钟及其悬挂支撑系统建立了有限元模型,进行了撞钟过程有限元瞬态分析及动力强度校核。
3.
This paper analyzes the characteristic of non standard hydraulic cylinders, discourses upon the general scheme of the CAD of non standard hydraulic cylinders, and emphasizes on discussing the implementing method of the dimension driving module and intensity checking module.
分析了非标准液压缸的特点 ,论述了非标准液压缸CAD总体设计方案 ,着重分析讨论非标准液压缸CAD系统中尺寸驱动模块和强度校核模块的实现方法。
6) strength checking
强度校核
1.
Study on strength checking data model for pump parts;
水泵零件强度校核软件数据模型的建立
2.
The Date-base system of pipe flange achieve the inquiring and strength checking of date about national standard pipe flange,and optimize the flange s dimensions if satisfied strength, and achieve the batch strength checking of FEA in Date-bas
所建立的管道法兰数据库系统实现了国家标准管道法兰数据的查询与强度校核 ,在满足强度条件下优化法兰尺寸 ,在数据库中实现有限元强度校核的批处
3.
Strength calculation and checking of key pumps parts have great effects on performance and lifespan of complete machines, conventional methods of strength checking could hardly meet the demands in design precision and efficiency.
水泵关键零件的强度计算与校核直接关系着整机的性能、使用寿命及可靠性,传统的水泵零件强度校核方法在精度、效率等方面已远远满足不了生产的要求。
补充资料:铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条