1) Gunning
[英]['gʌniŋ] [美]['gʌnɪŋ]
喷补
1.
Development and Application of Unshaped Refractory for Gunning Repair of Lime Kiln Lining;
采用不定形耐火材料喷补修复石灰窑炉衬的研制及应用
2.
Application study of gunning on 90t ladle slag line at Baotou Steel;
包钢90t钢包渣线喷补工艺的应用研究
3.
Application of remote hot gunning technology to the No1 BF at Baoshan Iron & Steel Co.;
遥控喷补技术在宝钢1号高炉上的应用
2) spray repair
喷补
1.
Hot-spray repair technology development in copper-smelting furnace;
铜冶炼炉热喷补技术开发
2.
Through the research and practice of the gunned refractory of an industrial furnace lining and spray repair technology, it is fully proven that the prepared LGJ- 01 gunned refractory has the characteristics of little linear change, good binding properties, lower rebounding rate and excellent heat shock stability.
介绍了工业窑炉内村喷补料及喷补工艺的研究及实践，充分证明LG－01喷科料具有烧后线变化小、粘结强度高、反弹率低、热震稳定性好等特点。
3.
1 BF cooling stave in small areas,furnace shutdown,spray repair,and furnace lining was used to BF inwall,which save a lot of investment and time in comparison with bricklaying repair.
临钢1号高炉在冷却壁局部损坏时,停炉对内壁进行喷补。
3) gunning material
喷补料
1.
The effect of the Fe2O3 content in gunning material on the ability to resist CO damage,and the reaction mechanism of the carbon disposition in refractories are analyzed.
以自行开发的适用于高炉中上部使用的喷补料为基料,通过添加Fe2O3粉改变料中的Fe2O3含量,研究了Fe2O3含量对高炉喷补料抗CO破坏能力的影响,初步分析了产生破坏作用的机理。
2.
The resisting ability of gunning material for blast furnace to CO corrosion was invesitigated under the pure CO and the mixed gas condition through adding hydrogen into pure CO.
通过在反应气中加入氢气，研究此种气体组成条件下，喷补料抗CO侵蚀能力。
3.
This paper described the effect of Fe2O3 content in gunning material for blast furnace on its resistance to CO.
研究了高炉喷补料中Ｆｅ_２Ｏ_３的含量对其抗ＣＯ侵蚀的影响，研究表明，随喷补料中Ｆｅ_２Ｏ_３含量增加，其抗ＣＯ侵蚀能力急剧降低，因此减少喷补料中Ｆｅ_２Ｏ_３的含量有利于提高其抗ＣＯ侵蚀能力，延长炉衬寿命。
4) hot-spray-mending
热喷补
1.
The hot-spray-mending of iron ladle in Chang Steel is introduced.
介绍了长钢应用的铁水罐热喷补技术,罐体修补时间由原来的2～3天缩短为30min左右,罐体运行寿命大大延长,并且极大地节约了筑罐成本和减轻了工人的劳动强度,取得了良好的经济效益和社会效益。
5) spray-repair vehicle
喷补车
1.
Structure and character analysis of spray-repair vehicles used in the snorkel of RH vacuum chamber;
RH真空室插入管喷补车结构与性能分析
6) spray-repair quality
喷补质量
补充资料：耐火喷补料
分子式：
CAS号：
性质：用喷射机进行喷补施工用的混合料。它是由具有一定粒度组成的耐火骨料和粉剂、结合剂和外加剂（促凝剂、增塑剂和助烧结剂或发热剂等）组成。喷补方法有湿法喷补、干法喷补和火焰喷补等三种。碱性喷补料主要用于修补钢铁和有色金属的熔炼炉和容器；硅酸铝质喷补料用于修补加热炉、均热炉、锅炉等；锆质喷补料用于修补玻璃熔窑；碳化硅质喷补料用于修补高炉出铁沟内衬。
CAS号：
性质：用喷射机进行喷补施工用的混合料。它是由具有一定粒度组成的耐火骨料和粉剂、结合剂和外加剂（促凝剂、增塑剂和助烧结剂或发热剂等）组成。喷补方法有湿法喷补、干法喷补和火焰喷补等三种。碱性喷补料主要用于修补钢铁和有色金属的熔炼炉和容器；硅酸铝质喷补料用于修补加热炉、均热炉、锅炉等；锆质喷补料用于修补玻璃熔窑；碳化硅质喷补料用于修补高炉出铁沟内衬。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条