1) high boron cast steel
高硼铸钢
1.
Effect of quenching temperature on microstructure and hardness of high boron cast steel;
淬火温度对高硼铸钢显微组织和硬度的影响
2.
Structure and performance of high boron cast steel liner;
高硼铸钢衬板的组织和性能
3.
A high boron cast steel with high strength and wear-resistant is obtained by adding 1.
0%B,获得了高强度高硼耐磨铸钢,并研究了淬火温度对高硼铸钢显微组织和性能的影响。
2) high boron steel
高硼钢
1.
Simulating different solidification cooling rate with step-metal mould and sand mould,the effect of solidification cooling rate on microstructure and properties of high boron steel were studied.
利用阶梯型腔金属模和砂型模拟不同的冷却速度,研究了冷却速度对高硼钢凝固组织和性能的影响。
2.
5% B high boron steel under the non-vacuum and vacuum condition, the B content of the high boron steel was analyzed and the B recovery rate was calculated.
5%的高硼钢,并取样分析高硼钢中B含量、计算B回收率,讨论分析试验过程中影响B回收率的因素,结果表明,熔炼时加入Ti,Zr以及稀土能对稳定B回收率起到积极作用。
3) High-Carbon boron steel
高碳硼钢
1.
The high-carbon boron steel was treated by compound rare earth modification,the impact abrasive wear properties of modified high-carbon boron steel was studied and compared with high chromium cast iron(Cr26)in the dynamic load abrasive tester MLD-10.
对高碳硼钢进行稀土变质处理,在MLD-10动载磨料磨损试验机上研究了变质高碳硼钢的冲击磨料磨损性能,并与高铬铸铁(Cr26)进行了比较。
4) high chromium cast steel
高铬铸钢
1.
The laser melting was performed on high chromium cast steel nozzle of power boiler burner.
对电站锅炉燃烧器喷嘴用高铬铸钢材料进行了激光熔凝处理,研究了激光熔凝处理后高铬铸钢表面熔凝层的显微组织、相结构、维氏硬度及耐磨性能。
2.
This paper deals with the granular carbides formation from hot deformation in high chromium cast steel.
本文探讨了热变形高铬铸钢中颗粒状碳化物的形成。
5) high silicon cast steel
高硅铸钢
1.
Microstructure and mechanical properties of austempered high silicon cast steel;
等温淬火高硅铸钢的显微组织和机械性能
2.
The microstructure and morphology of retained austenite of austempered high silicon cast steel after various austempering combinations are investigated by TEM,and the volume fraction of retained austenite is measured by XRD method.
采用透射电子显微镜(TEM)对高硅铸钢等温淬火热处理后的显微组织以及残余奥氏体分布形态进行了研究,对等温淬火组织中残余奥氏体量进行了测定,结果表明,残余奥氏体呈薄膜状及块状两种分布形态。
3.
The volume fraction and carbon content of retained austenite in the austempered high silicon cast steel after various austempering combinations were investigated by XRD method.
采用X射线衍射对高硅铸钢等温淬火热处理后的残余奥氏体量以及残余奥氏体含碳量进行了测定。
6) high-manganese cast steel
高锰铸钢
1.
The results show that it has not only better operational performance but also better oasting property as compared with the high-manganese cast steel.
结果表明，与高锰铸钢比较，中路抗磨铸钢不仅具有良好的使用性能，而且具有较好的铸造性能。
补充资料：氮化硼纤维增强体(见氮化硼纤维)
氮化硼纤维增强体(见氮化硼纤维)
boron nitride fibre reinforcements
然1‘珊升莱增强体boronments以氮化硼为主要成分，njtride fibre reinforce-用作陶瓷基、今星其有合材料增强体的一种无机纤维(见氮化硼纤维)。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条