1) Fe-Al coating
Fe-Al涂层
1.
Al/Ni coating and Fe-Al coating using for the bonding coaling were obtained by plasma spraying.
用等离子喷涂技术制备了用作粘结底层的Al/Ni、Fe-Al涂层,研究对比了这两种涂层在锌液中的耐腐蚀性能。
2.
Results show that with the increasing of temperature,the corrosion rate of all Fe-Al coatings also increased,the corrosion resistance of the Fe-Al coating with addition of Cr3C2 is superior to those without or with addition of WC.
结果表明:随温度升高,4种Fe-Al涂层的腐蚀增重都增加,添加Cr3C2比添加WC或不添加任何增强的Fe-Al涂层有更高的耐腐蚀性。
2) Fe-Al/Cr3C2 coating
Fe-Al/Cr3C2涂层
3) TiC/Fe Al composite coating
TiC/Fe-Al涂层
4) Fe-Al/SiC composite coating
Fe-Al/SiC复合涂层
1.
Fe-Al/SiC composite coating was made by HVFS.
利用高速火焰喷涂技术制备出Fe-Al/SiC复合涂层,在MM-A1立式磨损试验机上对涂层常温下的摩擦磨损特性进行研究。
2.
It indicated that the matrix of Fe-Al/SiC composite coating was Fe-Al phase (Fe3Al,FeAl) and SiC hard phase distributed all over the coating, and the coating displayed the typical layers structure characteristics.
采用高速火焰喷涂技术制备了Fe-Al/SiC复合涂层,对涂层在650℃下的热腐蚀动力学规律进行了研究,并利用扫描电镜(SEM)、能谱仪(EDS)和X射线衍射仪(XRD)对涂层及腐蚀产物的成分和形貌进行分析。
3.
In order to solve the hot corrosion problem on the water-wall tubes in thermal power plants, HVFS technology was used to prepare the Fe-Al/SiC composite coating, and the bonding strength, micro hardness, thermal shock and hot corrosive resistance performance of the coating were studied.
为解决火电厂锅炉水冷壁热腐蚀问题,采用高速火焰喷涂技术首次制备出Fe-Al/SiC复合涂层,并对涂层的结合强度、显微硬度、抗热震性能和耐热腐蚀性能进行了研究。
5) Fe-Al/Cr_3C_2 composite coating
Fe-Al/Cr3C2复合涂层
6) iron-aluminide and alumina composite coating
Fe-Al/Al2O3复合涂层
补充资料：Au-Pd-Cr-Pt-Fe-Al-Y alloys
分子式：
CAS号：
性质：金基与钯、铬、铂、铁、铝和钇的多元合金，电阻系数最高。生产方法参见金钯铬合金。可用作高温应变材料。
CAS号：
性质：金基与钯、铬、铂、铁、铝和钇的多元合金，电阻系数最高。生产方法参见金钯铬合金。可用作高温应变材料。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条