1) reduction rate of finishing rolling
终轧变形量
2) the reduction ratio of the final cold rolling
终轧形变率
1.
The effects of TMT aging temperature and time, the reduction ratio of cold rolling between the two-step aging processes, especially the reduction ratio of the final cold rolling on the properties and microstructures of hot-rolled C194 alloy during TMT were studied by low DC resistance tester, vickers hardness tester, OM and SEM.
5%、二次时效(500℃×2h+500℃×2h)、一次时效后以50%形变率冷轧,二次时效后终轧形变率为60%,轧制路线为1。
3) rolling reduction
轧制变形量
1.
Effect of rolling reduction on quench sensitivity of aluminium alloy 7A55;
轧制变形量对7A55铝合金淬火敏感性的影响
4) cold rolling reduction
冷轧变形量
1.
Cold-rolling process is a important stage in Ti+P-IF steel manufacturing process,and cold rolling reduction is main parameter.
冷轧生产工艺是Ti+P-IF钢生产中的重要环节，冷轧变形量是Ti+P-IF钢冷轧生产中主要的工艺参数，研究不同变形量下Ti+P-IF钢再结晶组织和织构的变化规律，有重要的理论和实际意义。
2.
The change regularity of the recrystallization microstructures and textures for Ti+P-IF steel in the different cold rolling reduction is studied by such means as the microstructure observation,TEM analysis and texture measurement.
采用金相组织观察、TEM分析和织构测试等手段,对Ti+P-IF钢在不同冷轧变形量下再结晶组织和织构的变化规律进行了研究。
5) total cold rolling reduction rate
冷轧总变形量
6) cold rolling
冷轧变形
1.
The effect of cold rolling deformation prior to aging on the strengthening of a maraging steel was investigated.
系统研究了预先冷轧变形对马氏体时效钢强化的影响,研究结果表明:510℃×3 h时效引起的强度净增加值恒定,与冷轧变形量无关,最终的强度为:σ=σ0+ΔσCR+ΔσAge,即初始强度、冷加工强化和时效强化的叠加,其中只有冷加工强化ΔσCR随变形量变化。
2.
The article introduces microstructure evolution and mechanical hardening of three different kind steels during cold rolling.
本文介绍了三种钢在冷轧变形过程中的组织演变和形变强化规律，发现三种钢具有不同的形变强化规律。
补充资料：薄终
1.谓不能善终。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条