1) forming process
成型过程
1.
Finite element simulation on the forming process of cold extruding for the starlike sleeve of constant speed cardan joint of car;
轿车等速万向节星形套冷挤压成型过程有限元模拟
2.
Compared with project practice, the theoretical and experimental study on the forming process of welded pipe is scarcely done and it is also very difficult to solve it in the finite element method, because the process is multi-nonlinear coupled problem that includes large deformation elastic plastic and nonlinear contact, till now the entire numerical simulation study on it has not been done.
直缝焊管成型过程属于弹塑性大变形和接触非线性多重非线性耦合问题，使理论研—A究和实验研究远落后于工程实践，即使采用有限元法也存在很多困难，目前还没有完整的数值模拟研究工作。
2) molding process
成型过程
1.
A dynamic method for investigating the molding process and the mechanical strength of solid catalyst was presented.
引 言目前国内绝大多数工业催化剂的成型过程工艺都是由经验决定的 ,往往缺乏催化剂成型基础理论的系统研究 。
2.
It analysed its formation character, and based on non-linearity finite element it wrote analysis program for emulational calculation, then it studied force and distortion during the molding process, at last ,it summarized the condition which insure the structure molding and established theory base for practice.
介绍了一种新型的大跨度空间结构形式———张拉整体桁架结构(STRARCH),分析了该结构的构造特征,根据非线性有限元方法编写了分析程序进行了仿真计算,研究了结构成型过程中的受力和变形特点,总结了确保结构成型所应该满足的条件,为实际工程应用奠定了理论基础。
3.
The injection mould CAE can analyze and simulate the molding process in computer and forecast the disadvantages of the design before the injection moulds are made.
本文应用Moldflow/MPI 注塑分析软件,针对赛马汽车复杂内塑料饰件的整个注塑成型过程进行注塑参数预分析,确定了制件成型的参数。
5) injection molding process
注塑成型过程
1.
Design of supervision system and research on monitoring methods for injection molding process will greatly improve the plastic production quality and promote the development of plastic industry.
本论文以注塑成型过程为研究背景，在查阅了大量国内外相关文献的基础上，首先综述了注塑成型工艺流程，介绍了注塑机控制系统及过程监测发展现状。
6) Squeezing process of Forming
成型挤压过程
补充资料：轿车用钢板成型过程模拟
在轧制过程中，由于各种因素的影响，带材在辊缝中的纵向延伸沿宽度方向常常是不均匀分布的。这种沿宽度不均匀延伸的结果导致轧后带材内部存在着沿宽度方向不均匀分布的纵向残余应力，当超过一定临界值时，轧后带材将产生波浪和翘曲。 | ||
| ||
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条