1) molybdenum disulfide
二硫化钼
1.
Influence of molybdenum disulfide on properties of NBR compound;
二硫化钼对NBR胶料性能的影响
2.
Research on preparation of molybdenum disulfide nanoparticles by homogeneous precipitation method;
均匀沉淀法制备纳米二硫化钼粉末的研究
3.
Study of Preparation of Fined Molybdenum Disulfide Powder by Ball Milling;
球磨细化二硫化钼粉末的试验研究
2) MoS_2
二硫化钼
1.
Study of the Tribological Behavior of Kaolinite Based Geopolymer Composites Filled with MoS_2;
二硫化钼填充高岭土基矿物聚合物复合材料的摩擦学性能研究
2.
Study on the Friction and Wear Properties of Polyimide Composites Filled with Polytetrafluoroethylene and MoS_2;
聚四氟乙烯和二硫化钼填充聚酰亚胺复合材料的摩擦磨损性能研究
3.
TRIBOLOGICAL PROPERTIES OF HYBRID CARBON FIBER AND MoS_2 REINFORCED POLYAMIDE 1010 COMPOSITES;
碳纤维和二硫化钼混杂增强尼龙复合材料的摩擦学性能研究
3) MoS2
二硫化钼
1.
Study on the Surface Oxidation Behaviour of MoS2(Ⅱ) Oxidation and Electron Transfer on the Friction Surface of MoS2;
二硫化钼表面氧化行为的研究（Ⅱ）─—二硫化钼摩擦表面氧化与电子转移的研究
2.
Three methods,the electrophoresis aggradation,brushed coating and water cooking method were presented to deposit MoS2 coatings in the material surfaces,and the deposited mechanisms were analyzed.
选用电泳沉积法、刷涂法和水煮法3种方法在材料表面制备了二硫化钼涂层,并探讨了3种方法形成涂层的机制。
3.
UNMWPE composites filled with nano-meter SiC, microfine glass bead, MoS2 and other fillers separately were prepared by means of in-situ polymerization and the properties of the composites were test.
用原位聚合法制备了分别加入纳米碳化硅、玻璃微珠、二硫化钼等填料的超高摩尔质量聚乙烯复合材料, 测试了其性能,并对原位聚合法和共混法的复合材料材料性能进行了对比。
5) molybdenum disulfide (MoS_2)
二硫化钼(MoS_2)
补充资料：二硫化钼
| 二硫化钼 molybdenum disulfide 辉钼矿的主要成分。棕黑色固体。化学式MoS2，熔点1185℃，密度4.80克／厘米3（14℃），莫氏硬度1.0～1.5。1370℃开始分解，1600℃分解为金属钼和硫。315℃在空气中加热时开始被氧化，温度升高，氧化反应加快。二硫化钼不溶于水，只溶于王水和煮沸的浓硫酸。二硫化钼的制法有：①将钼和硫直接化合。②三氧化钼与硫化氢气体作用。③将三氧化钼、硫、碳酸钾的混合物一起熔融。二硫化钼是重要的固体润滑剂，特别适用于高温高压下。它还有抗磁性，可用作线性光电导体和显示P型或N型导电性能的半导体，具有整流和换能的作用。二硫化钼还可用作复杂烃类脱氢的催化剂。 |
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条