1) tensile deformation
拉伸变形
1.
Study on tensile deformation characteristic of CrMnN stainless steel with metastable austenite;
含亚稳奥氏体铬锰氮不锈钢的拉伸变形特性研究
2.
Interfacial structure and tensile deformation behavior of 16Mn/Zn composites
16Mn/Zn复合材料界面组织结构与拉伸变形行为
3.
By using a mesomechanical analysis device,it was observed that during the tensile deformation of a copper bicrystal,the slipping ways and deforming amounts of two grains with different orientations are differential.
利用介观力学观察设备对Cu双晶拉伸变形行为进行了研究。
4) tensile deformation
拉伸形变
1.
Thermal activation volume V, activation enthalpy △H, activation free enthalpy △G and activation entropy △S of tensile deformation of a gamma titanium aluminide have been measured in a temperature range from low temperature(285 K) to 1273 K.
8TiB2）在屈服点的热激活参量：激活体积V,激活焓△H，激活自由焓△G和激活熵△S；据此推断控制γ－TiAl合金拉伸形变的微观位错机制。
5) draw textured yarn
拉伸变形丝
1.
Following some alterations, good quality draw textured yarn was produced at speeds of up to 2 200 m/min.
应用该工艺和新型的设备 ,速度在 2 2 0 0m /min时 ,仍能生产出品质良好的拉伸变形丝。
6) drawing deformation
拉伸变形率
1.
The conventional method of testing the shed drawing deformation of travellers is of poor precision and difficult operation.
目前纺纱用钢丝圈开口拉伸变形率的测量采用人工方法,精度低,操作困难。
2.
Description is done to the development and application of testers of open drawing deformation of travellers.
钢丝圈开口拉伸变形率 ,是行业标准FZ/T 930 0 2— 2 0 0 2规定的测试项目。
补充资料：拉伸变形丝
分子式：
CAS号：
性质：在一台机器上连续或同时进行拉伸-假捻变形加工的成品丝。简称DTY。加工方法有内拉伸法和外拉伸法。内拉伸法，丝条在变形加工同时进行补充拉伸；外拉伸法，丝条先经拉伸，然后连续进行变形加工。一般以预取向丝为原丝。丝条性能和用途参见变形纤维。
CAS号：
性质：在一台机器上连续或同时进行拉伸-假捻变形加工的成品丝。简称DTY。加工方法有内拉伸法和外拉伸法。内拉伸法，丝条在变形加工同时进行补充拉伸；外拉伸法，丝条先经拉伸，然后连续进行变形加工。一般以预取向丝为原丝。丝条性能和用途参见变形纤维。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条