说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 低碳拉丝用钢
1)  low carbon steel for wire drawing
低碳拉丝用钢
1.
According to the collected statistic data of properties and composition of common low carbon steel for wire drawing,the appearing frequency distribution figures of composition and properties are plotted.
根据收集的普通低碳拉丝用钢的性能和化学成分的统计数据 ,绘出化学成分和力学性能的出现频率分布图 ,通过数学分析 ,建立起抗拉强度、下屈服强度、断后延伸率与C ,Si,Mn ,P质量分数的回归方程式。
2)  low carbon cold drawn steel
低碳冷拔拉丝钢
3)  pseudo rimmed steel
低碳易拉丝钢
1.
Adopting suitable technologies on six strand billet caster for pseudo rimmed steel including online oxygen measurement, aluminium wire feeding, controlling at a level of (40~50)×10 -6, protective casting and EMS, the quality of billet, the surface quality and drawing properties of wire rods have been improved.
对马钢新六机六流小方坯连铸机生产的低碳易拉丝钢的生产工艺进行了分析 ,认为新六流生产的低碳易拉丝钢 ,在采取了精炼站在线定氧喂铝线 ,将钢水活度氧控制在 ( 40~ 5 0 )× 10 - 6 ,同时连铸采取保护浇铸和电磁搅拌等技术后 ,铸坯质量的改善效果明显 ,轧制的盘条表面质量良好 ,拉拔性能比旧工艺明显提
4)  Low carbon steel wire
低碳钢丝
1.
To introduce natural aging of galvanized low carbon steel wire after softening treatment and effect of the aging on mechanical properties of steel wire.
介绍镀锌低碳钢丝经软化处理后产生的自然时效及其对钢丝力学性能的影响。
2.
To analyze the characteristics of the coal powder burning furnace The practice experiences of low carbon steel wire heat treatment with coal powder burning furnace are introduced Three pieces of norms about laying down the annealing technology of low carbon steel wire are pointed ou
分析燃煤粉炉的特点,介绍燃煤粉炉热处理低碳钢丝的实践经验,指出制定低碳钢丝退火工艺的3条准则。
3.
o introduce the drawing of low carbon steel wire without pickling and the keys to the technique.
介绍低碳钢丝无酸拉拔技术及无酸洗拉拔的技术关键,分析新工艺的优点,指出应进一步完善的技术要点。
5)  zinc-coated low-carbon steel armour
铠装用镀锌低碳钢丝
6)  steel for wire drawing
拉丝用钢
补充资料:拉丝
分子式:
CAS号:

性质:(一)胶黏剂在配制后因超过活性期,胶液部分凝聚所产生的在拉伸情况下成为丝状物的现象。(二)涂料在喷涂时雾化不好,致使涂料不能化为微细的雾滴而呈丝状喷出,所得的涂膜不能流平,出现了拉丝。原因是涂料施工黏度高,稀释剂溶解力差。宜选用适合的溶剂,调整到适宜施工黏度,使涂料在喷涂时能充分雾化,能流平,即可避免此弊病。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条