1) dehydrogenation annealing
去氢退火
1.
Susceptibility to hydrogen embrittlement and dehydrogenation annealing process of bainite steel used for crossing;
辙叉用贝氏体钢的氢脆特性及去氢退火工艺
2.
Improvement of Dehydrogenation Annealing Technology for Forgings of Steel 45Cr2NiMoVSi;
45Cr2NiMoVSi钢锻件去氢退火工艺的改进
3.
Based on the state of hydrogen in steel and the relation between the solubility and the diffusion coefficient of hydrogen , dehydrogenation annealing technology for forgings of steel 20CrNi2MoA has been scientifically designed.
分析了氢在钢中的存在状态,阐明了氢的溶解度与扩散系数之间的关系,据此,科学地设计了20CrNi2MoA 钢锻件的去氢退火工艺,该钢退火前的氢质量分数为(1。
2) Full H_2 Bell Annealing
全氢退火
3) hydrogen annealing
氢退火
1.
s:The effect of hydrogen annealing on the voids in large diameter Czochralski (CZ) silicon is investigated.
研究了氢退火对大直径直拉硅单晶中空洞型缺陷 (voids)的影响 。
2.
The effects of hydrogen annealing on silicon carbide films grown on Si (111) substrates by radio frequency magnetron sputtering at room temperature are investigated.
用射频磁控溅射法在常温硅衬底上制备了碳化硅薄膜并研究了氢退火对薄膜的影响 。
4) hydrogen annealing
氢气退火
1.
In this thesis, the effects of high temperature hydrogen annealing on oxygen precipitation, f.
本论文研究了高温氢气退火对直拉硅中氧沉淀、洁净区形成、热施主等氧的行为的影响，得到了以下结果： 研究了直拉(CZ)硅片、掺锗直拉(GCZ)硅片、掺氮直拉(NCZ)硅片经氢气和氩气氛下低—高缓慢升温(L-H Ramping)处理即：从800℃以1℃／min的升温速率升温到1050℃或1150℃并保温4小时后氧沉淀和洁净区形成的情况。
6) hydrogen annealing furnace
氢气退火炉
补充资料：软化退火(见低温退火)
软化退火(见低温退火)
soft-annealing
rU0nhUO tUihUO软化退火(soft一annealing)见低温退火。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条