1) Dynamic Contact Angle
动态接触角
1.
This was done by measuring the Dynamic Contact Angle(DCA)in water and by performing Electron Spectroscopy for Chemical Analysis(ESCA)on the pulp fibres.
通过测量水中的动态接触角(DCA)和浆中纤维的电子光谱来检测。
2.
A model to describe the motion of contact line and dynamic contact angle on rough solid surfaces was proposed.
提出一个粗糙表面上移动接触线和动态接触角的数理模型 :毛细数较低时表观接触线前缘存在极薄的前驱膜 ,表观接触线在“湿”固体表面上移动 ,不同于传统模型中认为表观接触线在“干”固体表面上移动 。
2) dynamic contact angle(DCA)
动态接触角(DCA)
3) apparent dynamic contact angle
表现动态接触角
4) dynamic contact
动态接触
1.
Non-Uniform Rational B-Spline (NURBS) is used to describe the curves of die cavity in this paper, and the treatment of the dynamic contact boundary between a workpiece and its die is emphatically researched.
采用非均匀有理B样条(NURBS)方法描述模具型腔曲线,系统地分析了基于NURBS法的工件与模具动态接触过程的变化机制,并提出了相关算法。
2.
In numerical simulation of the drawing process of plate material, in order to get reliable calculation results, the dynamic contact of the plate material with the die need to be simulated accurately.
在对板料拉伸成形过程进行数值模拟时 ,为获得可信的计算结果 ,需要准确地模拟出模具与板料之间的动态接触。
3.
②The dynamic contact analysis for curve-tooth bevel gear and hypoid gear is carr
②用有限元方法,对弧齿锥齿轮及准双曲面齿轮进行动态接触分析,得出齿轮啮合冲击激励及不同啮合位置齿面动态应力分布。
5) static contact angle
静态接触角
1.
Penetrating depth,penetrating speed and the static contact angle of the liquor on the cattle crust were determined.
四种类型的渗透剂被应用在皮革干填充配方中,考察了不同干填充配方的渗透深度、渗透速度以及填充液在革坯上的静态接触角。
2.
The hydrophobicity recovery of HTV silicone rubber after different corona duration was investigated with the static contact angle method.
通过电晕加速老化试验,采用静态接触角法研究了高温硫化(HTV)硅橡胶在电晕老化不同时间后的憎水性恢复,结果发现,5kV的工频交流电压下电晕5min后,硅橡胶的憎水性暂时丧失;电晕老化后不同时间试样的憎水性恢复呈现出不同的变化趋势,其憎水性恢复率随着电晕老化时间的增加经历了"增加-降低-增加-降低"4个过程;同时在电晕老化一定时间后,即使经历足够长时间,其憎水性仍不能恢复到初始水平。
3.
The special waterproof agent was added to the paper coatings,and the properties of the coated paper were evaluated by the Cobb value, static contact angle,ink absorption properties and picking velocity.
在涂布纸涂料中添加专用的防水剂,通过分析涂布后纸张的Cobb值、静态接触角、油墨吸收性能、表面强度等指标评价涂布纸的性能。
6) dynamic contact angle
动力接触角
补充资料：接触角(contactangle)
【接触角】(contactangle)相界面平衡时，与气-液-固三相交结垂直的平面内包含液相的夹角。用`\theta`表示。`\theta`与各相间界面张力的关系可用*杨氏方程式表示，即：`cos\theta=(\sigma_(Q,G)-\sigma_(Y,G))//\sigma_(Q,Y)`（Q为气相，G为固相，Y为液相），式中`\sigma`为界面张力，脚注表示界面的性质。当`\sigma_(Q,G)>\sigma_(Y,G)`，且`(\
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条