1) acidic copper and brass plating bath
酸性铜和黄铜电镀
2) acidic copper electroplating
酸性电镀铜
1.
Discussion on factors affecting quality of phosphorized copper anode used for acidic copper electroplating;
影响酸性电镀铜用磷铜阳极质量因素的探讨
3) brass plating
电镀黄铜
1.
The work principle of the brass plating technology with single wire control of the CPA Co.
介绍传统的钢帘线钢丝镀层工艺并分析存在的问题,说明CPA单丝控制电镀黄铜技术的工作原理,对新技术与传统技术生产效果进行比较,结果显示:使用新技术可将黄铜中铜质量分数的波动范围由±2％降低到± 1％,铜和锌的阳极消耗分别从先前的13 kg／t、7。
4) brass electroplating
黄铜电镀
5) acid copper plating
酸性镀铜
1.
The influences of the intermediate and monomer brighteners commonly used in present acid copper plating on the hardnes.
本文主要对目前国内外常见的酸性镀铜中间体、单体光亮剂对硬度的影响进行了测试研究。
2.
The absorption curves of the brightener UBAC 1A of bright acid copper plating and cupric sulfate of the bath were mensurated by experiments respectively.
通过实验分别测定了酸性镀铜光亮剂UBAC 1A和镀液中硫酸铜的吸收曲线。
6) acidic copper plating
酸性镀铜
1.
Experimental study was carried out on the preplafing technology of Acidic copper plating for iron and steel.
实验研究了钢铁件酸性镀铜前的预镀工艺,确定了硫脲浸铜工艺,讨论了工艺中各成分及含量对镀层结合力的影响,得到了硫脲浸铜工艺的成分及最佳含量,硫酸铜10～12g/L、硫酸75～100 mL/L、硫脲0。
2.
A brightener for acidic copper plating had been presented.
介绍了酸性镀铜光亮剂 ,并与使用较多的两种国外酸铜光亮剂的阴极极化曲线、镀液的深镀能力、均镀能力、耐温工作范围等作了对比。
3.
The formula for bright acidic copper plating technics and the operating conditions are presented and the acidic copper plating brightener is evaluated through comparative tests.
在酸性镀铜电解液中要获得良好的镀铜层,关键在于选择性能优良的酸性镀铜光亮剂,而酸性镀铜光亮剂的开发关键在于中间体的选择和复配。
补充资料：黄铜
见铜合金。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条