Interfacial Adhesion of GCr15 Bearing Steel and TiN Films Grown by Plasma Immersion Ion Implantation and Deposition;

A study of adhesion of nanometer amorphous diamond film on acrylic denture resin substrates;

Study on the Adhesion of Chemical Plating;

Causes for poor adhesion strength of electroplated coating to ABS plastic and their controls

The effects of depositing temperature on the thickness, adhesion strength and hardness of TiN film have been studied in this paper.

Cyanide-free pre-immersion can improve covering power and throwing power as well as the adhesion strength of coating.

To enhance the binding force between hard coating and a common structure steel substrate by ion nitriding;

The effect of different element contents of rare earth element Y on the binding force between ion plating TiN coating and substrate was studied.

Influence of the sputtering methods,processing parameters and interlayer on the binding force of the films were investigated.

Effects of annealing temperature on microstructure and cohesion of ZrW_2O_8 thin films;

The plating rate and cohesion of different structure coatings were measured.

With optical microscope, friction and wear spectrometer and scratch spectrometer, the influence of the parameters of sputtering time, sputtering power and interface layer on the film was studied The results showed that the friction factor of BN film was about half of that of the steel based materials, and the cohesion between film and substrate could obviously be.

The resultant deposit had advantages such as bright, smooth, good adherence and eliminated cross corrosion.

The rough surface offered more binding points,which could enhance the adherence between the coating and AZ91D Mg alloys,but the binding force was much more influenced by the compaction of the coating.

The film quality and particularity of Large area glass such as pin-holes adherence quality resisting abrasion uniformity, stability of chemistry optic quality quality of heating quality of electrics and so on, are analyzed and discussed in detail as soon as possible, which relate to coating equipment desposit technics coating material structure of films and many aspects of natural science.

The hardness,corrosion resistance,bonding force between coating and matrix and friction coefficient of the C/Cr composite coating deposited by non-equilibrium magnetron sputtering were analyzed.

The bonding between plating layer and base body,plating layer surface morphology were observed by SEM,and the hardness,bonding force and corro.

This paper studies the effect of the inner stress of the electroless Ni-plating on cement-based composites on the bonding force of the platings with the base,as well as the main source of the bonding force,based on which excellent technology for elec- troless Ni-plating has been found out,which has laid the basis for the electroless Ni- plating on MDF cement-based composites.