1) SiC nanowires
SiC纳米线
1.
Synthesis and characterization of SiC nanowires using silicon evaporation;
硅热蒸发法制备SiC纳米线及其结构表征
2.
Formation of SiC nanowires on SiO_2 substrate by magnetron sputtering and annealing;
石英衬底上磁控溅射SiC膜退火形成SiC纳米线
3.
SiC nanowires were found in crystallochemical analysis of SiBONC ceramic powder, which was synthesized through a polymer pyrolysis route from the raw materials of tetrachloride, phenyle aldehyde, boron trichloride and aniline.
在对SiBONC陶瓷粉末坯体进行高温气压处理时,发现在坯体表面生长出大量β-SiC纳米线。
2) nanometer SiC
纳米SiC
1.
Ni-P-SiC nanometer composite coating was prepared with electroless plating,and the effects of concentration of nanometer SiC particles in the solution on hardness of the coating were studied.
利用化学镀方法制备了Ni-P-SiC(纳米)复合镀层,研究了镀液中纳米SiC微粒含量对复合镀层硬度的影响,在MPX-2000型摩擦磨损试验机上进行了复合镀层与45钢配对的滑动磨损试验,用扫描电镜观察了磨损面的形貌。
2.
The effect of the content of the nanometer SiC particles on the microstructure and properties was discussed.
利用化学镀方法制备了Ni-P-SiC(纳米)复合镀层,研究了镀液中纳米SiC微粒的含量对复合镀层组织与性能的影响,结果表明:由于纳米SiC的加入,使复合镀时的镀速加快,原因是液固界面增加,从而增加了有效催化面积。
3.
The tribological behaviours of polyetheretherketone (PEEK) filled with nanometer SiC and micron SiC were studied.
利用热压法分别以纳米SiC和微米SiC作为填料制取了两类不同SiC填充的聚醚醚酮复合材料，并对它们在干摩擦条件下的摩擦磨损性能进行了研究，同时还用扫描电子显微镜对摩擦表面形貌进行了观察，进而对材料的磨损机理作了分析与讨论。
3) nano-SiC
纳米SiC
1.
A study on preparation and properties of Au/nano-SiC composite coatings;
Au/纳米SiC颗粒复合镀层的制备工艺及性能
2.
Study on nano-SiC/PA66 composite;
纳米SiC/PA66复合材料的研究
3.
Preparation of Cu/nano-SiC composite powder in disproportionation reaction and replacement reaction;
歧化反应及置换反应制备Cu/纳米SiC复合粉体
4) SiC nano-bar
SiC纳米杆
1.
Investigation of the SiC nano-bar relaxation characteristics;
SiC纳米杆的驰豫性能研究
5) Ni-(nano)SiC
Ni-纳米SiC
6) Ni/nano-SiC
镍/纳米SiC
补充资料：承纳
1.接受。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条