1.
Plywood--Determination of dimensions of test specimens
GB/T9846.10-1988胶合板试件尺寸的测量
2.
Decorative laminated sheets based on thermosetting resins--Determination of dimensions of test pieces
GB/T7911.2-1987热固性树脂装饰层压板试件尺寸的规定
3.
In strength property experiment, the sample size is 150×15×5mm.
在强度实验中试件尺寸采用150×15×5毫米。
4.
Can I try on this shirt in a bigger size?
我能试穿比这件衣服大一点的尺寸吗？
5.
I'll see if any of these jackets fit. Do you have this in a small size?
我想试穿这些茄克，这件有没有小号的尺寸呢?
6.
FEM Analysis on Dynamic J-integral under the Influence of the Specimen Sizes.;
试件几何尺寸对动态J积分影响的有限元分析
7.
Measurement of Key Dimensions of Large-size and Thin-wall Pieces Based on Vision Inspection Technology;
大尺寸薄壁零件关键尺寸的视觉检测
8.
testing method for sizing degree of paper (stoeckight method)
纸张尺寸试验方法（stoeckight法）
9.
testing methods for dimensions of refractory bricks
耐火砖尺寸试验方法
10.
modular and dimensional co-ordination concept
构件式组合及尺寸配合
11.
Dimensional tolerances for castings
GB/T6414-1986铸件尺寸公差
12.
OPTIMUM SIZE OF TRANSVERSAL ISOTROPIC SPECIMEN IN DYNAMIC TESTING USING THE SPLIT HOPKINSON PRESSURE BAR
横观各向同性材料动态力学性能试验中的试件最佳尺寸
13.
Prototype is a description of the dimensional measurements, material and performance tests that will occur during building of the prototype.
样件在样件制造过程中进行的尺寸测量材料和性能试验的描述.
14.
Raw Casting basic dimensions, in.,Over,Up to & including
毛坯铸件基本尺寸,英寸,大于,至
15.
An error occurred while trying to save the changes to the profile. The total size of the attributes is more than the maximum of 4096 bytes.
试图保存对配置文件的改动时出错。总尺寸超过 4096 字节。
16.
The effect of length due to shear localization is studied.
研究了由于剪切局部化而引起的试件长度的尺寸效应。
17.
It is possible to reduce hardware cost by testing smaller-sized.
采用较小尺寸的试验发动机可以减少零件的费用。
18.
The Research on the Relationship between the Polycarbonate Sheet Specimen Dimension and Plastic Target;
聚碳酸酯拉伸试件几何尺寸与塑性变形指标关系的研究