1.
Study on Machining Vestige Problem of Small Channel Turbine Blade with Shrouded
带叶冠小通道涡轮盘叶片加工中接痕问题初探
2.
Dual-mode Optimization Asymmetry Fuzzy Logic Controller Design for X Aeroengine MFP
某涡扇发动机主燃油通道模糊控制器设计
3.
Finite Element Analysis on Energy Flow Path of the Remote Field Eddy Current Effect
利用有限元法分析涡流远场效应的能流通道
4.
Experimental research of turbulated cooling hole machining by ECM
涡轮叶片竹节孔冷却通道电解加工实验研究
5.
Cooling Passage Design Optimization of Turbine Blades Based on Response Surface Methodology
基于响应面的涡轮叶片冷却通道设计优化
6.
Effect of different clapboards structure in turbine blade trailing edge complex passages on flow characteristics
涡轮叶片尾缘复合通道隔板结构对流动的影响
7.
INFLUENCE OF BLADE-STAGGER DEPARTURE ON THE MIGRATION OF HOT STREAK IN TURBINE PASSAGE
叶片安装角偏差对涡轮通道内热斑迁移的影响
8.
Numerical study on main shaft inner cooling channel of a micro turbojet
微涡喷发动机主轴内冷通道传热数值研究
9.
Study on the Discharge Coefficients of the Connecting Passage of the Combustion Chambers for Swirl ChamberDiesel Engines
涡流室式柴油机燃烧室连接通道流量系数的研究
10.
Heat Transfer Characteristics and Flow Behaviors of the Longitudinal Vortex Generators in the Channel Flow;
矩形通道内纵向涡发生器的换热和流动特性研究
11.
Simulation on the Vortex Shedding Caused by the Cross-flow over Plates in a Narrow Channel
窄通道中掠过平行板流动引起的漩涡脱落数值模拟
12.
Circuit Model of Power and Information Transmission Channel with Eddy Current Infuence in Fuze Induction Setting System
考虑弹体中涡流影响的引信感应装定能量和信息传输通道模型
13.
Simulation of the Effects of the Connecting Passage on Air Flow Field in the Swirl Chamber
发动机涡流室连接通道对空气流场影响的模拟研究
14.
Large-eddy simulations of thermal fluctuation for mixing of hot and cold fluids in T-junction
T型通道内冷热流体混合过程的热波动大涡模拟
15.
Digital scroll chiller design application in road traffic guidance command center building of xiao gancity
数码涡旋机组在孝感市道路交通管理指挥中心大楼的设计应用
16.
NUMERICAL OPTIMIZATION OF SPACING BETWEEN LVGs IN NARROW RECTANGULAR CHANNEL
窄间隙矩形通道内纵向涡发生器间距的数值优化
17.
Vortex Charges and Vortex State Phase Transitions in Superconductors;
超导涡旋电荷及磁通涡旋态相变研究
18.
The snowflakes were swirling about (the streets).
雪花在 (街道上) 涡旋。