1.
NONAXISYMMETRIC CASING ON AXIAL-FLOW COMPRESSORS
轴流压气机非轴对称机匣造型的研究
2.
Computation of Lubricant Temperature at Outlet of Accessory Gearbox
附件机匣出油口润滑油温度计算方法
3.
Research on Collision Stability of Nonlinear Rotor-stator Box System
非线性转子-机匣系统碰撞稳定性分析
4.
The Mechanism Research of Circumferential Grooves Casing Treatment on Stability Extension of Inclined-flow Compressor
周向槽机匣处理对斜流压缩机扩稳的机理研究
5.
Study on Buckling and Fatigue Life of Composite and Aeroengine Composite Case
复合材料及发动机机匣的屈曲与疲劳研究
6.
Improvement of Bearing Bush Fixture in Accessory Gearbox for a Typical Engine
某型发动机附件机匣轴承衬套固定结构的改进
7.
Transient dynamical analysis of aero-engine combustor outer casing
航空发动机燃烧室外机匣瞬态动力分析
8.
Theory and Experimental Study on Aeroengine Casing Containment;
航空发动机机匣包容性理论和试验研究
9.
Research on the Strength and Life of the Engine Intermediate Case under Multiaxial Loads;
多轴载荷下发动机中介机匣强度与寿命研究
10.
Experiments and Simulation of the Blade Containment in the Aeroengines;
航空发动机机匣包容性的试验研究与仿真计算
11.
Influence of Stepped Tip Gap Casing on Centrifugal Compressor Performance
梯形间隙处理机匣对于离心压气机性能的影响
12.
Effect of exciting frequency of casing treatment on transonic compressor performances
处理机匣激励频率对跨声速压气机性能的影响
13.
Numerical analysis of two circumferential groove casing treatments about a centrifugal compressor
离心压气机周向槽机匣处理方案的对比分析
14.
Dynamics Analysis of Vibration Transmission for Inner and Outer Cases of a Gas Turbine
某型燃气轮机内、外机匣振动传递的动力学分析
15.
Whenever you handle a firearm or hand it to someone, always open the action immediately and visually check the chamber, receiver and magazine to be certain they do not contain any ammunition.
当你要将枪递给别人时，一定要拉开枪机并保持开膛状态，机匣和弹匣内都不能有子弹。
16.
A Study of the Stability Enhancement Achieved by the Casing Treatment of an Oblique-flow Impeller Equipped with a Rear-mounted Volute Housing
带后置蜗壳的斜流叶轮机匣处理扩稳研究
17.
Effects of casing air injection position on controlling tip clearance flow in axial turbines
机匣喷气位置对涡轮间隙流动控制的影响
18.
Gas piston rod and receiver. Note the recess on the bottom of the receiver, it is for the bolt locking.
导杆及枪匣，注意枪匣内下方的凹槽，供枪机闭锁用。