1.
Position the lower suspension arm at the axle bracket and rear bracket.
把下端悬吊臂放在车轴支架和后侧支架上。
2.
Install steering damper onto the axle bracket and drag link.
安装转向阻尼器至轴支架和转向拉杆。
3.
Hyperworks-based Topology Optimization for Balance-axle Brackets
基于Hyperworks的平衡轴支架拓扑优化设计
4.
Remove the upper suspension arm nut and bolt at the axle bracket.
从车轴支架上拆去上端悬吊臂螺帽和螺栓。
5.
Remove the lower suspension arm nut and bolt from the axle bracket.
从车轴支架上拆去下端悬吊臂螺帽和螺栓。
6.
Loosen but do not fully remove the four bolts that attach the stabilizer bar bushing retainers to the rear axle brackets.
松开但不完全拆卸接合稳定杆衬套扣环与后车轴支架的4支螺栓。
7.
Tilt seatback forward, and slide it outboard to detach it from pin on center pivot bracket.
向前倾斜座椅靠背，向外部滑动，从中心枢轴支架销上将其卸下。
8.
The carriage is supported on guide shafts.
托架支承在导轴上。
9.
Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;
长轴深井泵轴承支架水力参数的探讨
10.
Remove nuts, U-bolts and spring bracket from axle.
由车轴拆下螺帽，U型螺栓和弹簧支架。
11.
Remove nut securing pedal shaft in support bracket.
拆卸支撑托架上连接踏板轴的螺帽。
12.
Mode and Finite Element Analysis of the Centrifugal Pump Bearing Bracket;
离心泵轴承支架的模态及有限元分析
13.
Radius arms, cross members, radius arm brackets and cross member brackets rebuilt or modified for new axle locations.
根据新的前后桥的位置，对半轴，十字轴及相关支架进行改造。
14.
The rear axle used on front wheel drive applications of this vehicle is mounted to the rear leaf springs using isolator bushings at the axle mounting brackets.
车轴利用轴固定支架的绝缘衬套固定于后叶片弹簧。
15.
Analysis and Treatment of Oil Leakage at Flange Coupling Rotor Spider and Main Shaft of Unit
机组转子支架与主轴联轴法兰处漏油分析及处理
16.
If the first axis is perpendicular to the ground we speak of an azimuthal mounting.
如果第一根轴与地面垂直，就称为地平式支架。
17.
The Application of Coaxial Electrospinning in the Surface Modification of Tissue Engineering Scaffolds;
同轴电纺在组织工程支架表面改性中的应用
18.
The effect of self-assembled nanofiber scaffold by gene recombination on axon growth of the neurons
基因重组自装配多肽支架促进神经元轴突生长