1.
Topology Optimization under Multi-load Cases Based on Element-free Galerkin Method
多载荷工况下无网格Galerkin法的拓扑优化
2.
Buckling and Dynamical Behavior of Complex Structures under Various Loading;
复杂结构在多种荷载工况下的屈曲及动力分析
3.
The Stress Analysis of Hub Bearing Based on Multi-bench Test Load
基于多工况台架试验载荷的轮毂轴承受力分析
4.
Internal Force Analysis Method & Research on Bridge Crane′s Double-Beam Structure under Multiple Operating Loads
多工况载荷作用下的桥式起重机双梁结构内力分析方法研究
5.
Methods Analysis of Load Cases Designing on Horizontal Axis Wind Turbine
水平轴风力机载荷工况设计方法研究
6.
Load Case Check and Analysis of Girder Delivery and Installation on High-Speed Passenger Railway;
高速铁路客运专线运架梁荷载工况检算与分析
7.
no-load position
无负荷(情况)，不带负载
8.
This thesis on research dynamical loads on rubber transmitting belts used in driving pumping unit with long-stroke, especially the influence of the elasticity on rubber transmitting belts and work condition is discussed.
分析了长冲程抽油机传动胶带中的动载荷,重点讨论了胶带弹性及抽油机工况对动载荷的影响。
9.
Study on the Loads Equivalence and Transferring Behavior of the EPB Shield Machines Penetrating in the Heterogeneous Geological Conditions
异质岩土工况下土压平衡盾构载荷等效及传递特性研究
10.
Construction of Standing Seam Roof with CladdingDecoration Panel under Condition of Heavy Load Concentration
直立锁边屋面板外挂装饰板在大集中荷载状况下的施工
11.
A Brief Discussion about Effects of Forward Moving of Quality and Technology Control Points based on Payload Operational Condition
从载荷工况出发浅析质量技术控制点前移的作用
12.
Numerical Methods for Limit Analysis and Reference Stress Determination of Structures under Multi-Loading Systems and Their Engineering Applications;
多组载荷下结构极限分析和参考应力确定的数值方法及工程应用
13.
Rated operating load for loaders
GB/T10175-1988装载机额定工作载荷
14.
Numerical analysis of effects of multiple injection on emissions under high load of turbocharged diesel engine
多次喷射对增压柴油机高负荷工况排放影响的数值分析
15.
The Multimode Measurement Based on Immune Principle for the Load of Car-engine Job Status Parameter
基于免疫原理的发动机工况参数负荷的多模态测量
16.
Design and Construction of Steel Double-deck Grid with Large Load
某工程大荷载双层钢网架设计与施工
17.
load and fouling hull operating mode management
装载和污底工况管理
18.
Distributed loadis regarded as polynomial function or uniformly distributed moment alh ng the edge.
荷载采用了多项式形的分布荷载及均布边缘力矩。