1.
Failure Behaviors of Cu/Ni Multilayer Film under Multiple Impacting and Repeating Press Load
Cu/Ni多层膜在多冲与压压载荷下的失效行为
2.
joint contact surface
连接接触面总压紧载荷
3.
The smallest load capable of maintaining the bar in a slightly bent form is called the critical or bucking load.
使杆保持稍微弯曲形状的最小载荷称为临界载荷或临界压曲载荷。
4.
Analysis of Estimating Ultimate Loading and Static Test of Screw Pile Under Inclined Loading
承压螺旋桩斜向荷载试验与极限荷载判定分析
5.
A Study of Computation Model with Load-structure Method for Unsymmetrically Loaded Closely-spaced Tunnel;
偏压小间距隧道的荷载结构特性研究
6.
Calculate Approximately Critical Load of Tenuous Long Compressive Bar by Chart Multiplication Method;
细长压杆临界载荷的图乘法近似求解
7.
The Calculatiou of critical load by torsion angle-bending moment matix;
用转角弯矩矩阵确定压杆的临界荷载
8.
Simultaneous Topology and Shape Optimization of Pressure Loaded Structures
压力载荷下的结构拓扑-形状协同优化
9.
Strut-and-tie Model of Deep Beam Design Under Uniform Distributed Loads
均布荷载下深梁设计的压杆-拉杆模型
10.
Stress analysis of pipeline subject to surface load
地面占压荷载作用下的管道应力分析
11.
Fatigue Behavior of 6063 Alloy under Tension and Combined Tension and Torsion Loadings
拉-压及拉-扭载荷下6063合金的疲劳行为
12.
Research of Pulse Load Servo System Hydraulic Pressure Load Simulateion;
脉冲载荷随动系统液压负载模拟的研究
13.
Air Pressure and Load Influence on Ground-contact Behavior of TBR Tire
气压和载荷对载重子午线轮胎接地性能影响
14.
Cracks may initiate in compression, and certainly in tension.
裂缝可能在压缩载荷下形成，当然也可能在拉伸载荷下形成。
15.
Dead weight loading simulating that of the bolts was applied at the bolt holes through the agency of steel balls and buttons.
螺栓荷载是用死荷重来模拟的，以钢球和压钮作为代用件，通过它们将此荷载施加于螺栓孔。
16.
The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing and brineling.
为了避免划伤和压坑，轴承上的最大负荷应该总是小于其卸载负荷。
17.
Study of Smart Behavior of Carbon Fiber Reinforced Cement-based Composites under Compression
受压荷载下碳纤维水泥基复合材料机敏性研究
18.
Multi-load model for reliability assessment of HVDC converter
高压直流换流器的多载荷可靠性评估模型(英文)