1.
"This movement causes the pitman arm, attached to the sector, to swing to the right or left. This action, in turn, pushes or pulls on the tie rods attached to the pitman arm."
这一运动又依次推动或拉动与转向摇臂相连的转向直拉杆。
2.
steering drag link rear end grease fitting
转向纵拉杆后端油嘴
3.
steering knuckle tie rod end pressure lubricator
转向节横拉杆接头油嘴
4.
Install steering damper onto the axle bracket and drag link.
安装转向阻尼器至轴支架和转向拉杆。
5.
Tie Rod End To Steering Knuckle Nut
转向拉杆端与转向关节螺栓
6.
To brace(a yard)fore and aft.
使船转向向首尾拉紧（横桅杆）
7.
steering knuckle tie rod end assy
转向关节横拉杆接头总成; 转向节横拉杆接头总成
8.
CALCULATION OF SHEARING STRESS FOR AXIAL DRAWING OF TRANSFORM SECTION BAR
变截面直杆轴向拉伸时的剪应力计算
9.
Remove the cotter pin and nut from the drag link at the pitman arm.
从转向拉杆上拆下转向摇臂处的开口销和螺母。
10.
Torquing Tie Rod End Attaching Nut
拧紧转向拉杆端接合螺帽
11.
Remove cotter pins and nuts from drag link
从转向拉杆上拆下开口销和螺母。
12.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓
13.
The Development of Motor Steering Link and Bar Test Bench
汽车转向拉杆接头总成试验台的开发
14.
Aileron servo pull rod should be vertical to the shaft of aileron basically.
副翼舵机拉杆应基本上垂直于副翼转动轴线。
15.
steering lever for road motor vehicles (excl. motor cycles) or tractors
转向杆,道路机动车辆（不包括摩托车）或拖拉机
16.
Research on Measurement and Control System for Automotive Steering Rod Ball Joint Test Bench
汽车转向拉杆球接头试验台测控系统研究
17.
Development and Research for the Test-bench Used for the Car Steering Linkage and Assembly
汽车转向拉杆球接头试验台的开发研究
18.
The torsion vibration of a pole with crack along the shaft direction and its discussion
存在轴向裂缝的等直圆杆扭转振动及其讨论