1.
" Bolts, screws and studs--Nominal lengths, and thread lengths for general purpose bolts"
GB/T3106-1982螺栓、螺钉和螺柱的公称长度和普通螺栓的螺纹长度
2.
Theoretical Analysis and Test of Ordinary Bolt Used on Anti-fatigue Rail
抗疲劳钢轨普通螺栓的理论分析与试验
3.
Analysing the accurate solution of the common stud bolt connection acted by the turning moment
旋转力矩下普通螺栓联接的精确解分析
4.
The method is employed for the optimal design for tight joints of ordinary bolt set on a hydraulic cylinder.
并用该法对液压油缸的普通螺栓组紧联接进行了优化设计。
5.
DISCUSSION AND SUGGESTION ON WHETHER THE INFLUENCE OF PRY FORCE IN THE DESIGN VALUE OF TENSILE STRENGTH OF GRADE C ORDINARY BOLT IN CODE IS CONSIDERED
规范中C级普通螺栓抗拉强度设计值是否考虑撬力影响的探讨与建议
6.
Fasteners--Clearance holes for bolts and screws
GB/T5277-1985紧固件螺栓和螺钉通孔
7.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
8.
" Fasteners--General requirements for blots,screws,studs and nuts"
GB/T16938-1997紧固件螺栓、螺钉、螺柱和螺母通用技术条件
9.
By analysis, bolt fatigue stress is marginally high.
通过计算分析,螺栓的疲劳应力稍偏高。
10.
Screw thread shanks for thread forming screw--Metric coarse thread series
GB/T6559-1986自攻锁紧螺钉的螺杆粗牙普通螺纹系列
11.
double-screw bolt
螺柱，双头螺纹螺栓
12.
The valve cover shall be held in place through the use of a single grooved style two-bolt coupling.
阀盖应该通过单个沟槽状双螺栓联结器固定住。
13.
Analyze on bolt pre-tightening force control methods of Ba-Tong damper
八通缓冲器联接螺栓预紧力控制方法分析
14.
"Bolt: Mechanical fastener, usually used with a nut, for connecting two or more parts."
螺栓:通常与螺母一起用于连接两个或更多零件的机械紧固件。
15.
General purpose screw threads--Diameters and pitches
GB/T193-1981普通螺纹直径与螺距系列(直径1~600mm)
16.
Dead weight loading simulating that of the bolts was applied at the bolt holes through the agency of steel balls and buttons.
螺栓荷载是用死荷重来模拟的，以钢球和压钮作为代用件，通过它们将此荷载施加于螺栓孔。
17.
Handle assembly is removed by loosening bolt and pulling upward. Remove the two hold-down bolts and lift index plate from valve.
通过松懈螺栓并拔出方法拆卸手柄总成。拆卸两个紧固螺栓，提起阀门上的刻度板。
18.
draw-bar carrier bolt
牵引杆托(板)螺栓