1.
Theoretical and Experimental Research on Hydrodynamic Characteristics of Rotor-Foil Bearing System
转子—箔片轴承系统动力学特性理论及试验研究
2.
Different means to improve the load capacity were compared through load capacity coefficient.
本文还以承载力系数为依据,比较了提高箔片轴承承载力的方法。
3.
Analysis of foil predeformation influence on the static characteristics of bump foil journal bearings
箔片预变形对箔片气体径向轴承静特性影响分析
4.
An Analysis of a Compliant Multileaf Journal Self-Acting Air Bearing Unite with Active Magnetic Bearing;
磁气混合轴承中弹性箔片径向动压气体轴承的数值分析研究
5.
Modeling and Numerical Analysis of Foil Hydrodynamic Thrust Bearing Used in Turbine Generator
涡轮发电机轴向箔片气动轴承的建模与数值分析研究
6.
A TURBO-REVERSE BRAYTON AIR REFRIGERATOR WITH FOIL GAS JOURNAL BEARINGS
使用箔片径向气体轴承的透平逆布雷顿循环空气制冷机
7.
The elasto-aerodynamically coupled solution can be an effective method for the load-performance prediction of aerodynamic compliant foil bearings.
气弹耦合解是准确预测弹性箔片动压气体轴承承载性能的有效方法。
8.
RESEARCH OF WORK ROLL CHOCK DYNAMIC CHARACTERISTICS ON 2350ALUMINIUM FOIL MILL;
2350铝箔轧机工作辊轴承座动态特性研究
9.
Aluminium foil :Aluminium sheet or coil rolled to a thickness of less than 0.15mm.
铝箔：轴压至小于0.15毫米厚的铝片或铝卷。
10.
The Application of a Single Chip Processor 8098 to Detecting the Axial Clearance of a Bearing
8098单片机在轴承轴向间隙检测中的应用
11.
Design and Remaking of Temperature Control System for Oil Mist Lubrication of Work and Backup Roll Bridle Roll Bearings Box for Foil Mill
箔材轧机工作辊、支撑辊、张紧辊轴承箱油雾润滑温度控制系统的设计改造
12.
Research on Inner Rotor Type Disk Bearingless PM Motor;
内转子式片状无轴承永磁电机的研究
13.
Finite Element Analysis of Bearing in Segment Erector System for TBM
TBM管片拼装系统轴承有限元分析
14.
foil coating, film coating
箔片涂层,薄膜涂层
15.
foil made of tin or a tin-lead alloy.
用锡或锡合金做的箔片。
16.
porous-foil electrolytic capacitor
多孔箔片电解电容器;多孔箔片电解质电容器
17.
Remove the depth shims from rear pinion bearing cup bore in axle housinRecord the thickness of the depth shims.
从轴管里的后小齿轮轴承盖孔拆卸限深垫片。记录限深垫片厚度。
18.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）