1.
Fuzzy-logic Applied to Yaw Moment Control for Vehicle Stability;
基于模糊逻辑横摆力矩控制的汽车稳定性研究
2.
Direct Yaw Moment Control of Four Wheel Steering Vehicles and Hardware in Loop Simulation System;
4WS车辆直接横摆力矩控制与硬件在环仿真系统
3.
The Research of Electrionic Stability Program Control Based on Direct Yaw Moment Control
基于直接横摆力矩控制的汽车ESP控制系统研究
4.
Integrated Vehicle Control of Four Wheel Steering and Direct Yaw Moment Control
直接横摆力矩与四轮转向集成控制研究
5.
4WD Vehicle DYC Based on Tire Longitudinal Forces Optimization Distribution
基于全轮纵向力优化分配的4WD车辆直接横摆力矩控制
6.
Integrated Active Steering and Yaw Moment Control for Improving Vehicle Handling and Stability;
联合主动转向和横摆力矩控制的汽车操纵稳定性研究
7.
Linear Parameter-varying Modeling Method Based Gain-scheduling Control of Yaw Moment for Vehicle Stability
基于线性变参数建模的汽车横摆力矩增益调度控制
8.
With the increase of the relative velocity, the variations of side force coefficient and yawing moment coefficient of the overtaken vehicle will increase linearly.
被超车侧向力系数和横摆力矩系数的变化量随两车相对车速的增加呈线性增加的趋势。
9.
A control system was proposed to improve braking distance and stability by the integrated control of yaw-moment control and active front steering.
提出一种结合横摆力矩控制和主动前轮转向控制的提高紧急制动侧偏稳定性的控制方法.
10.
yawing moment of inertia of sprung mass
簧上质量横摆惯性矩
11.
Complete Balancing for Shaking Force and Shaking Moment of Eight-Bar Linkages
铰链八杆机构摆动力和摆动力矩的完全平衡
12.
The simulation algorithms of wave high, yaw force, rolling moment and sway moment were put forward.
给出了随机海浪波高、横荡力、横摇力矩、艏摇力矩的仿真算法。
13.
Study on the Simulation and Control Strategy for Yaw Motion Dynamics of Tractor-semi Trailer
半挂汽车列车横摆动力学仿真及控制策略研究
14.
Dynamic analysis of side throw of woodworking band saw blades based on the frequency control
变频调速下木工带锯条横向摆动动力特性分析
15.
The Backlash Adjustment Moment Analysis on Double Cycloid no Backlash Steel Backlash Steel Ball Trausmlssion
双摆线无隙钢球传动间隙调节力矩分析
16.
STUDY ON CUTTING FORCE IN RECTANGULAR GROOVE CUTTING AND SIDE DEFORMATION OF CHIP
矩形槽切削的切削力及切屑横向变形的研究
17.
Similar cyclic stresses may have occurred due to wind-induced swaying motion during storage.
同样在存放时由风力引起的横向摆动也可以产生类似的循环应力。
18.
The pendulum-torque type of erector is extensively employed on gyro verticals.
陀螺垂直器上广泛地采用由摆和力矩马达组成的修正装置。