1.
Method B:Infused a fixed volume of 10 mL air. Method C:Inflated the cuff till air leakage just disappeared judged by using a stethoscope. Results CP1 was(52.40±(8.08)cm H_2O).
结果入ICU首次套囊压力为(52.40±8.08)cm H2O。
2.
Allows for individual calibration of gradient pressure at each and every sleeve section.
使用者可自行调校各个压力套的压力。
3.
Effect of Inflated Endotracheal Tube on the Tracheal Morphology in Rabbit;
套管气囊压迫对兔气管组织形态结构的影响
4.
bradenhead squeeze pressure
关闭井口套管闸门形成的挤压压力
5.
Measurement and Research of the Dynamic Pressure of the Gasbags during the Process of Ship Launching by Using Gasbag
船舶气囊下水过程中气囊动态压力测试与研究
6.
A small, sometimes microscopic capsule designed to release its contents when broken by pressure, dissolved, or melted.
微胶囊，微囊体小团胶囊，在压力、溶解或熔化时破裂释放出所含物质
7.
Connector for pressure gauge--Assembly
GB/T3751.1-1983卡套式压力表管接头
8.
Connector for pressure gauge-Boby
GB/T3751.2-1983卡套式压力表接头体
9.
WORK NEW GROMMETS INTO PLACE USING FINGER PRESSURE ONLY
仅用手指压力将新套环装配到位
10.
INFLUENCE OF TEMPERATURE ON CONTACT PRES- SURE OF CASING JOINTS
温度对套管接头螺纹接触压力的影响
11.
The Study on Rational Flooding Pressure in Casing Damage Area of No.2 Block of Pubei;
葡北二断块套损区合理注水压力研究
12.
Study on Mechanical Properties of Pressed Loose Steel Pipe Flanges
冲压松套钢制管法兰的力学性能研究
13.
Pressure Calculation of Powder Gas in Bush Radial Clearance
衬套径向间隙部位火药气体压力计算
14.
Centrifugal Casting of Cylinder Liner of Air Compressor Used for Mine Electric Locomotive
矿用电力机车空压机缸套的离心铸造
15.
Optimum Design of the Radial Interference Magnitude of Shrunk Pressure Vessels
热套压力容器半径过盈量的优化设计
16.
Numerical Simulation on the Unidirectional Extruding Capacity of Downhole Casing
井下套管单向挤压承载能力数值模拟
17.
Discussion on Earthing Modes of High Voltage Bushing End Shield in Power Transformer
电力变压器高压套管末屏接地方式问题探讨
18.
Besides,the author believesit isno need to deflate the cuff at fixed time and it isenough to adjust the cuff pressure casually.
认为气囊不需定时放气,只需不定时调整气囊压力。