1.
A Study of Depth of Cervical Intraepithelial Neoplasia Glandular Involvement and the Extent of Cervical Conization;
宫颈上皮内瘤样病变累腺深度与锥切范围研究
2.
A study of depth of cervical intraepithelial neoplasia glandular involvement and the extent of cervical conization
宫颈上皮内瘤变累腺深度与锥切范围的研究
3.
Analysis of pregnancy after cervical conization and radical surgery
子宫颈锥切术及根治性宫颈切除术术后妊娠的分析
4.
taper wire-cut EDM machine
锥度电火花线切割机床
5.
tangent-cone of a qualric
二次曲面的切线锥面
6.
55 inch thread tagential die for taper pipe
55°英制圆锥管螺纹切线平板牙
7.
This product is a new-generation initiatory toy for baby;2、 Guide baby to correctly know various geometries such as triangle, hemicycle, rectangle etc.3、 Train baby's ability of practice and thought;4、 Arouse baby's imagination so bring into play creativity during actual operation.
⒈静?肥切乱淮?挠锥?裘赏婢撸
8.
A conic section whose plane is not parallel to the axis, base, or generatrix of the intersected cone.
圆锥的一部分，其切面既不平行于轴和基面，也不平行于圆锥母线
9.
Study on Klingelnberg Bevel Gear Interference with the Cutter and Machining Calculating;
螺旋锥齿轮切齿计算及干涉情况的研究
10.
Tooth Contact Analysis and Cutting Parameters Modification of Small-modulus Spiral Bevel Gears;
小模数弧齿锥齿轮的接触分析与切削参数修正
11.
The Design of Large Taper Wire Electrical Discharge Machining's Number Control System;
大锥度电火花线切割机数控系统的设计
12.
Study on Cutting Process Simulation of Bevel Gears and the Software Development;
锥齿轮切齿仿真方法及其软件系统研究
13.
Integrative Hypersonic Waverider Design Based on Osculating Cones Method;
基于密切锥方法的高超声速乘波机一体化设计
14.
Discussing based on cutting method of conical cylinder with plane arc axes;
平面大圆弧轴线圆锥柱体切削机理研讨
15.
Four Propositions and Their Applications of a Straight Line and a Conic Section Being Tangent;
直线和圆锥曲线相切的若干命题与应用
16.
Clinical analysis of pregnancy after cervical cone excision in 15 cases
宫颈病变锥形切除术后妊娠15例临床分析
17.
Modified General Electrosurgical Knife Conization:Analysis of 210 Cases
改良普通电刀宫颈锥形切除术210例临床分析
18.
Gear-Cutting Adjusting Calculation Method for the Rolling Modification of Main Transmission Bevel Gear of Automotive Rear Axle
汽车后桥主传动锥齿轮滚切修正切齿调整计算方法