1.
Research on natural gas hydrate while depressurizing
管输节流降压过程中水合物形成研究
2.
Optimization design and experimental model analysis of complex throttle injection with small apertures spray muffler
节流降压-小孔喷注消声器优化设计与模态分析
3.
Low temperature separation, uses the high energy from the wellstream to throttle and reduce pressure, then remove the condensate.
低温分离,是利用地层本身能量节流降压制冷,用低温分离方法脱除天然气中凝液的处理工艺。
4.
However, caution must be exercised to avoid extremely close throttling when pressure drop exceeds20%.
但是,必须注意的是避免在压降超过20%情况下进行极端关闭节流。
5.
Joint protection to reduce stress on joints.
保护关节,以降低对关节的压力。
6.
The Energy-Saving Plan about High Pressure Sodium Lamp and Some Subsistent Problems in the Condition of Reduction Voltage
高压钠灯降压节能方案及存在的问题
7.
hydraulic hitch system with throttle control
节流式液压悬挂系统
8.
Reduced pressure near the partially closed throttle valve caused the fuel to flow from the idling jet into the intake air.
由于部分关闭的节流阀附近的压力下降,燃油由怠速喷口喷入吸进的空气。
9.
Slip steady economy power research for induction motor
异步电动机降压恒转差节电效果分析
10.
Saving the energy of campus power network;
高校校园低压电网的节能降耗之我见
11.
Optimization Control and Economize on Energy for Turbine Compressor
透平压缩机组的优化控制与节能降耗
12.
Analysis of Harmonics and Effectiveness of Electronic Buck Electricity Saving Device
电子降压型节电器的谐波问题及节电效果分析
13.
New Regulator Architecture for Voltage or Current Regulation
用于电压或电流调节的新调节器架构
14.
The Study of Low-Voltage High-Current Output Voltage Regulator Module;
低压大电流电压调节模块(VRM)的研究
15.
Domestic 300 MW Circulating fluidized bed boiler energy saving
国产300MW循环流化床锅炉的节能降耗
16.
The Method of Saving Energy on DC Switching Mode Power Supply
论直流开关电源节能降耗的工程措施
17.
bias set circuit
偏压调节电路偏流调节电路偏磁调节电路
18.
Minimal pressure drop if full-port selected
选择不缩径全流道结构时,压降最小