1.
Effect of extrusion speed on formation of nascent PAN hollow fiber
喷丝速度对PAN中空纤维成形的影响
2.
The size of the filament is also controlled by varying the rate at which the filaments are pulled away from the hole by the godet wheel.
长丝的直径还与导丝盘从喷丝头孔引离长丝时的速度有关。
3.
outlet triangle
喷嘴出口速度三角图
4.
Research about Nozzle Discharge Speed Distribution for Meltblown Model
熔喷模头喷嘴孔流场速度分布的研究
5.
Speed Control Switch Mounting Screws
速度控制开关固定螺丝
6.
Study on the properties of 3Cr13 tubeliner coatings prepared by highspeed electrie arc spraying;
高速电弧喷涂3Cr13管状丝材涂层性能研究
7.
Study on Minimum Spouting Velocity in Liquid and Solid Bed with Draft Tube
带导流管液固喷动床的最小喷动速度研究
8.
The desirability of providing a high hydrogen injection velocity and a low oxygen injection velocity has been previously discussed.
上面已经讨论过，希望能够提供高的氢喷射速度和低的氧喷射速度。
9.
The Humidity Effect on the Discharge Coefficient of Sonic Nozzles
湿度对音速喷嘴流出系数影响的研究
10.
Effect of velocity ratio on combustion process gas-gas injector
速度比对气-气喷嘴燃烧性能的影响
11.
Estimation Method of Nozzle Exit Speed for Torpedo Turbine Engine
涡轮发动机喷管出口速度的估计方法
12.
Such high-speed jet aircraft have a speed of 700m.p.h.
这样高速喷气式飞机的速度为700英里/小时。
13.
High temperature instantaneous supersonic flow measurement using hydroxyl tagging velocimetry
高温瞬态超音速喷流OH分子示踪速度测量
14.
Study on Inter-electrode Flow Field in Low-speed Wire-cut Electric Discharge Machine Based on Composite Cooling Liquid
基于复合工作液的低速运丝电火花线切割喷液极间流场研究
15.
Fully accelerating abrasive particle velocity to near water-jet velocity is main aid of nozzle design.
喷嘴设计的主要任务就是要使从喷嘴喷出的磨料粒子得到充分加速,以便接近水射流的速度.
16.
While increasing the diameter of spinneret hole, the filament diameter of PET POY was increased, both the orientation and the birefringence of PET filament were decreased.
随着喷丝孔孔径的增大,涤纶POY单丝直径增大,单丝的取向度降低,双折射率减小。
17.
Uniform and stable wire feeding speed which ensures fast and reliable ignition.
送丝速度一致、平稳,保证起弧快捷、可靠。
18.
The size of the filament depends on the rate of flow through the hole of the spinneret rather than on the size of the hole.
所制成长丝的直径取决于粘胶的喷丝头孔中的流速,而不取决于孔径的大