1.
Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment
面内弯矩下双弯头组合管件的极限载荷研究
2.
Study on the Linear Ultrasonic Motor Based on In-plane Bending Modes of Piezoelectric Rectangular Composite Laminated Plates;
矩形复合层板面内弯曲模态直线超声电机研究
3.
Numerical Simulation of Flow Characteristics in a Curved Rectangular Duct for Small Curvature Ratio
小曲率矩形截面弯管内流动特性数值模拟
4.
Experimental Verification on the Calculation of the Castellated Beam-Columns′ Stability and Carrying Capacity in Plane
蜂窝式压弯构件弯矩作用平面内稳定承载力计算的试验验证
5.
The Study on In-Plane Equivalent Bending Moment Coefficient of Tapered Portal-Frame-Column without Brace
无侧移楔形变截面门式刚架柱平面内等效弯矩系数研究
6.
A Method of the Moment Diagram for Predicting the Deflection of Structure and Its Application;
结构位移计算的弯矩图面积法及应用
7.
Analysis of Moment-curvature Hysteresis Behavior of Composite Beams
组合梁截面弯矩—曲率滞回性能分析
8.
The concrete wall is suffered with horizontal shear force and moment in the plane of the wall.
通常钢筋混凝土墙主要用于承受水平剪力作用及承受墙平面内的弯矩作用。
9.
The Test and Theory Study in the In-Plane Stability Capacity of Hot-rolled H-section Columns under Eccentric Load;
热轧H型钢偏心受压构件在弯矩作用平面内极限承载力的理论与试验研究
10.
Experimental Research on the Flexural Performance of the RC Beam Strengthened by Bongding the CFRP Sheets on Lateral Side;
CFRP侧面加固钢筋混凝土梁负弯矩区抗弯性能试验研究
11.
Interface Slip and Full Process Analysis of Double Steel-Concrete Composite Beam under Negative Bending;
钢－混凝土双面结合梁负弯矩区滑移及受弯全过程分析
12.
In this Paper, the moment-curvature-axial force relationships of reinforced concrete rectangular section are discussed.
本文讨论了钢筋混凝土矩形截面弯矩—曲率—轴力关系.
13.
Discussion about"Analysis of Correlation Curves between the Axial Force of Eccentrically Pressed Member with Rectangular Cross Section and the Bending Force Moment;
关于“矩形截面偏心受压构件轴力——弯矩相关曲线分析”的探讨
14.
The equation of five moments of continuous beam with step cross section on the elastic support
阶梯状变截面弹性支座连续梁的五弯矩方程
15.
Out-of-Plane Bending Moment Analysis of the Plastic Limit for the Welded Piping Tee Containing Bottom Thinning Defects
底部减薄焊制三通的塑性极限面外弯矩分析
16.
Research on Flexural Behavior of Reactive Powder Concrete Rectangular Beam with Steel Bars;
活性粉末混凝土矩形截面配筋梁抗弯性能研究
17.
A Solution Method of the Bending Moment of the Statically Indeterminate Beam with Constant Cross Section and Single-span;
等截面单跨超静定梁固端弯矩的一种解法
18.
Probing into the relation between moment modification factor and section corner of the reinforced concrete structure;
钢砼结构弯矩调幅系数与截面转角关系的探讨