1.
Finite Element Analysis of Dynamic Characteristics and Checking of Lateral Stiffness of Lattice Light-Gauge Joist Steel System
格构轻钢龙骨体系动力特性有限元分析及抗侧力刚度验算
2.
Experiential Calculation for Leaf Spring with multi Auxiliary Leaf Andy Way
渐变刚度板簧(多片副簧)的经验算法
3.
Experiential Calculation for Leaf Spring with Single Auxiliary Leaf Andy Way
渐变刚度板簧(单片副簧)的经验算法
4.
Calculation and Analysis of Accumulator for the Test of the Impedance of Hydraulic Booster Location System
舵机动刚度试验台蓄能器的计算与分析
5.
Verifying Calculations on Formulas of Oblique Penertation of Projectile into Eeinforced Concrete
刚性弹丸斜撞击下混凝土板侵彻极限深度计算方法的对比验算
6.
Calculation and test of intensity and strength for Joint airproof structure at Front and back junction of Fiber wraped shell structure
纤维缠绕壳体前后接头连接密封结构强度和刚度计算与试验
7.
The load, radial stiffness, axial stiffness and angular stiffness of precision spindle were formulated.
推导出精密主轴承载、向刚度、向刚度和角刚度的计算公式。
8.
Study on Improved Algorithm of the Time-varying Meshing Stiffness of Gear and Stiffness Excitation
齿轮时变啮合刚度改进算法及刚度激励研究
9.
Where required, to examine deflections, stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions.
必要时验算挠度、刚度要求、以及任一特殊材料和设计规定，以预防不利条件下的脆断。
10.
Rotational Stiffness of Plated Column Base and Effective Length of Columns
平板柱脚的转动刚度和柱的计算长度
11.
On Calculation of Kinetic and Acceleration Energy of Rigid Body and Its System
关于刚体及刚体系的动能及加速度能计算
12.
Effective Length Factor of Columns in Two Web and Top-seat Angle Semi-rigid Connected Steel Frames;
四角钢半刚性连接刚架柱计算长度系数
13.
Cantilever method
悬臂式测定法,刚软度测定法《试》（织物刚性试验）
14.
Computation and test showed that the variation of magnetic force and bearing rigidity increases along with the reduction of axial magnetic gap and the augment of clearance between magnets.
计算和试验表明，随着磁隙的减小，磁块间隙的增大，磁力和刚度的变化增大。
15.
I have been spending part of my time tonight in reckoning how I stand.
刚才我盘算了半夜功夫我该取何态度。
16.
Analysis and Study on Supporting Stiffness of High-speed Spindle System;
高速轴系支撑刚度的计算分析与研究
17.
Precamber Calculating and Controlling of Continuous Rigid Frame Bridge
连续刚构桥施工预拱度的计算与控制
18.
ANALYSIS ON ASME FLANGE DESIGN RIGIDITY CALCULATION METHOD
美国ASME法兰设计刚度计算方法分析