1.
Study on load-carrying capacity of aluminum cover & clip contact in the glass curtain wall
玻璃幕墙中扣座压板之间接触受力性能研究
2.
Remove the push-in fastener from the top of the fan shrou
从风扇围板顶部拆下压入扣件。
3.
Cold-extrusion process and die design of plane-chair-clasp cylinder
航空座椅锁扣缸体冷挤压工艺及模具设计
4.
Press the cowl top trim panel down until the snap clip retainers engage in the top of the instrument panel.
向下压仪表板顶部饰板，直至夹扣定位器啮合到仪表板顶部。
5.
Numerical Modeling Method for the Clip Connecting Profiled Metal Slab s Ultimate Resistance;
扣合连接压型钢板承载力有限元数值模拟
6.
Analysis of Compression Modulus of Resilience of Slab-Type Rubber Seat of Bridge
桥梁板式橡胶支座抗压弹性模量分析
7.
Remove push-in fastener attaching trim cover to door inner panel (use special tool C-4829).
拆下把装饰盖板固定在车门内板的压入式钩扣（用特殊工具C-4829）。
8.
Study for Press Forming Process of Car Seat Side Member
轿车座椅侧板支架的冲压成形工艺研究
9.
Numerical Simulation of FEM of Automobile Seat Side Blank Stamping
汽车座椅侧板冲压成型有限元数值模拟
10.
Upper cutter roller holder and upper line pressing roller holder are controlled pneumaticaly, so there is no need to cut paper board and stop for order change.
上刀?座与上压线?座升降以气压方式控制，故在更换订单时不必切断纸板及停机.
11.
If both clips separate from the floor carpet cover, the cover may lean toward the accelerator pedal, causing interference with the accelerator pedal rod.
如果两个固定卡扣同时从地毯压板上脱落，地毯压板可能向加速踏板倾斜，从而同踏板杆产生干涉。
12.
high back-pressure and low oil pressure trip
高背压和低油压脱扣
13.
To fire the gun, pull the trigger.
要开枪就扣动板机。
14.
Position striker on B-pillar.
将扣击板安放在B-柱上。
15.
The hunter pulled the trigger and stopped the deer in his tracks.
猎人扣板机，鹿应声而倒。
16.
The soldier pressed the trigger of his gun.
战士扣动枪的板机。
17.
Study on Topology Optimizaion of Structural System Composed of Plate and Its Application in Hydraulic Press Support Design;
板系结构拓扑优化及其在液压机底座设计中的应用研究
18.
bearing oil pressure trip device
轴承低油压脱扣装置