1.
" End-suction centrifugal pumps (rating 16 bar)--Designation, nominal duty point and dimensions"
GB/T5662-1985轴向吸入离心泵(16bar)标记、性能和尺寸
2.
End-suction centrifugal pumps--Baseplate and installation dimensions
GB/T5660-1985轴向吸入离心泵底座尺寸和安装尺寸
3.
End-suction centrifugal pumps--Dimensions of cavities for mechanical seals and for soft packing
GB/T5661-1985轴向吸入离心泵机械密封和软填料用的空腔尺寸
4.
axially injection forward-wave amplifier tube
轴向注入前向波放大管
5.
Design of dynamic vibration absorbers to reduce axial vibration of propelling shafts of submarines
基于动力吸振器的潜艇推进轴系轴向减振研究
6.
Specification: direction of rotation of output shaft varies with that of input shaft.
说明：当输入轴旋转方向改变，输出轴相应改变。
7.
In order to take lateral flow into account it is necessary to postulate the shape of the bearing.
为了计入横向流动，必需设定轴承形状。
8.
When swinging transmission machine operation, the force constant rotation axis to make efforts before and axial rotation move backward.
当摇摆传动机械运行时，等速旋转入力轴使出力轴向前和向后旋动。
9.
Energy Absorption Analysis of Thin-walled Structures under Axially Impact;
轴向冲击下薄壁组合结构吸能特性分析
10.
Studies on the axial dynamical buckling and energy-absorption properties of aluminum foam-filled circular tubes
泡沫铝填充圆管轴向动力屈曲及吸能特性研究
11.
Research on Axial Injection System of Cyclotron Virtual Prototyping;
回旋加速器虚拟样机轴向注入系统设计研究
12.
Axial Entrance Hydrocyclone for Oil-Water Separation and its Numerical Simulation
轴向入口油水分离水力旋流器及其数值模拟
13.
Experimental investigation on the energy Absorption characteristic of braided composite circular tubes subjected to quasi-static axial compression
编织复合材料圆管准静态轴向压缩吸能特性的试验研究
14.
EXPERIMENTAL STUDIES ON THE AXIAL CRUSHING BEHAVIORS OF ALUMINIUM FOAM-FILLED HAT SECTIONS
泡沫铝填充帽型结构轴向压缩吸能特性的试验研究
15.
A Study on the Energy Absorption Characteristics of MWK Reinforced Structure Due to Low Velocity Impact;
多轴向经编针织结构增强材料低速冲击能量吸收特性研究
16.
The crankcaseventilation system, using a road-draft tube, vented the crankcase vapors and blow-by gas into the atmosphere.
采用行车抽吸管的曲轴箱通风系统，给曲轴箱内的蒸气和窜漏气体排入大气提供了出口。
17.
When swinging drive mechanical operation, such as the rotation speed of the force to make efforts axial shaft before and backward rotation and enable higher plane.
当摇摆传动机械运作时，等速度的旋转入力轴使出力轴向前和向后旋转，并使平面升高。
18.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。