1.
Numerical Simulation of Flows in the Pump Sump under Multi-pump Operating Combination for Large Pump Stations;
多泵组合条件下泵站进水池流动数值模拟
2.
The large scale bend axis piston pump axial setting and pump package centre adjusting method
大型斜轴泵轴线设置与泵组中心调整方法
3.
Code for construction and acceptance of oil pump set
输油泵组施工及验收规范
4.
Pumps Unit Control of Constant-pressure Water-supply System Based on FIFO;
基于FIFO恒压供水系统的泵组控制
5.
Countermeasure and Causes which Affects the Actions of the Fire Pumps
影响消防泵组有效运行的原因及对策
6.
OPTIMIZED RETROFIT OF WARMING-UP FOR FEED-WATER PUMPS OF 200 MW UNITS
200MW机组给水泵暖泵方式的优化改造
7.
fuel dispensing pump assembly
燃料分配泵调节组合件
8.
Fuel Pump Module Locknut
燃油泵模组锁定螺帽
9.
MASTER CYLINDER/BRAKE BOOSTER ASSEMBLY
总泵/煞车倍力器组装
10.
While nimodipine was pumped into vein directitly in the control group.
对照组直接用微量泵泵入尼莫地平注射液。
11.
Analysis of Economical Efficiency of Changing Dynamoelectric Feedwater Pump into Steam Turbine-driving Feedwater Pump of a 210 MW Steam Turbine
210MW机组电动给水泵改汽动给水泵的经济性分析
12.
The tset method for electrical submersible pump units
GB/T16750.3-1997潜油电泵机组试验方法
13.
Electrical submersible pump--Technical specifications
GB/T16750.2-1997潜油电泵机组技术条件
14.
A set of pumps used in a mine.
一组唧筒矿井中使用的一套泵
15.
Install brake lines that connect master cylinder to combination valve.
安装连接总泵至组合阀的煞车管线。
16.
Position locknut over top of fuel pump module.
将锁定螺帽放在燃油泵模组上。
17.
Study and Practice of the Driving Mode of Feed Water Pumps for 200MW Units;
200MW机组给水泵驱动方式的研究与实践
18.
Control System Design and Exploitation of Small Ground Source Heat Pump Unit;
小型地源热泵机组控制系统设计开发