1.
Application Study of Gussasphalt Concrete on Pavement of Long Span Steel Deck
大跨径钢桥面浇注式沥青混凝土铺装应用研究
2.
Methods and Research on Deterioration of Steel Deck Gussasphalt Concrete Pavement;
钢桥面浇注式沥青混凝土铺装病害分析及对策
3.
Application Technique for Long Span Steel Deck Gussasphalt Concrete Pavement;
大跨径钢桥面浇注式沥青混凝土铺装技术研究
4.
The influence of the filler-asphalt ratio on the high-and-low-temperature performance of gussasphalt mortar
粉胶比对浇注式沥青胶浆高低温性能的影响
5.
The Application Research of Native Hard Bitumen in Gussasphalt;
国产硬质沥青在浇注式沥青混凝土中的应用研究
6.
Composition and Properties of Modified Mastic Asphalt Concrete at the Jiangyin Yangtze River Bridge Pavement
江阴长江大桥钢桥面铺装层改性沥青浇注式砼的组成与性能研究
7.
Design and Application of Gussasphalt Mixture Used in Beipanjiang Bridge Deck Pavement
北盘江大桥桥面铺装用浇注式沥青混合料配合比设计应用
8.
Development of JLSFW-10 Epoxyn Pouring Type Outdoor Three-phase Combined Transformer
JLSFW-10型环氧树脂浇注式户外三相组合互感器的研制
9.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
10.
The Environmental Aspects Analysis For Epoxy Cast Resin Dry-type Transformers
环氧树脂浇注干式变压器环保特性分析
11.
The new type insulation cylinder used in cast resin transformers
新型结构绝缘筒在浇注型干式变压器中的应用
12.
Analysis for thermal ageing problem of resin cast dry-type transformers
树脂浇注干式变压器热老化问题的分析
13.
Closed Integration System for Melting and Pouring Magnesium Alloy
封闭式镁合金熔炼及浇注集成系统的研究
14.
Study of the calculating formulas in the minimum section of the gray casting iron pouring system
灰铸铁件浇注系统最小截面积计算公式研究
15.
Design of Pb-Ca Alloy Automatic Casting System Based on The S7-300PLC
直线往复式铅钙合金自动浇注系统设计
16.
Application of Valve-gate Technology in the Control of Weld Lines of Large Injection Molded Products
阀式浇注技术在控制大型注塑件熔接痕中的应用
17.
The molten metal may enter the ingot mould in two ways: from the top and from the bottom. Top pouring is the simplest and cheapest method, but gives poor control over the rate of pouring.
钢液注入钢锭模可采用两种方式:上注和下注。上注法最简单，成本最低，但不好控制浇注速度。
18.
A new casting technology for inlet manifold in tilt casting machine for gravity die casting was described.
介绍了在可倾式金属型浇注机上制造进气歧管的铸造新工艺。