1.
Energy-saving Research of Multi-power Modes for Wheel Loader Engines
轮式装载机发动机多功率模式节能研究
2.
Microwave-Vacuum Drying of Carrot under Various Power Modes
胡萝卜在不同功率模式下的微波真空干燥
3.
Effect of Nodal Injection Power Mode on Voltage Stability Margin
节点注入功率模式对电压稳定裕度的影响
4.
Coupling design for high-power millimeter wave in the overmoded waveguides mode
高功率毫米波过模波导模式耦合设计
5.
Research on Power Control Mode for Grid-connected Doubly Fed Generator
并网型双馈发电机功率控制模式研究
6.
Research on Low-Power Single-Phase APFC Operating in CRM Mode with Frequency Limited;
限频临界断续模式单相小功率APFC研究
7.
Design and Realization of Energy Feedback Type Electronic Power Load;
电能反馈式电子模拟功率负载的研制
8.
An Active Power Compensation Model for Grid-connected Distributed Generation System
一种用于分布式发电系统的有功功率补偿模型
9.
induction type reactive power relay
感应式无功功率继电器
10.
Research and Development on Heat Pipe Heat Sink for Power Electronic Module;
热管式大功率电子模块散热器的研究与开发
11.
Research of High Power Microwave Mode Recognition Based on Far Radiation Field;
基于远区辐射场的高功率微波模式识别的研究
12.
Study on Behavioral Model of Power Amplifiers Based on Polynomial Structures
基于多项式结构的功率放大器行为模型研究
13.
Design of a BCM Power Factor Correction Circuit
一种临界导通模式功率因数校正电路设计
14.
The high-power TE_(01)-TM_(11) mode converter in bent circular waveguide
高功率弯曲圆波导TE_(01)-TM_(11)模式变换分析
15.
Measurement-based memory polynomial behavioral modeling of RF power amplifiers
基于测量的记忆多项式功率放大器特征模型
16.
Distributed motion control model and its power balance
分布式运动控制系统的控制模型及功率平衡
17.
Design of Active Power Factor Correction Based on CRM
临界导电模式有源功率因数校正器的设计
18.
Mode and Loss Analysis of High Power, High Voltage and High Frequency Transformer
大功率高压高频变压器模式和损耗分析