1.
Study for Press Forming Process of Car Seat Side Member
轿车座椅侧板支架的冲压成形工艺研究
2.
Numerical Simulation of FEM of Automobile Seat Side Blank Stamping
汽车座椅侧板冲压成型有限元数值模拟
3.
Position seat on floor pan.
在底板上定位座椅。
4.
Install screws attaching seat function switch to seat trim panel.
安装连接座椅功能开关至座椅饰板的螺钉。
5.
Remove the inboard seatback pivot bolt.
拆卸内侧座椅背枢轴螺钉。
6.
Disengage the cover zipper and route the zipper end between the inboard seatback and seat cushion frame.
取下盖拉链，并且确定在内侧座椅背和座椅垫架间的拉链末端路线。
7.
Remove the three screws that secure the seat side shield to the seat cushion frame.
拆卸固定座椅侧面防护至座椅垫支架的三个螺丝。
8.
Research on the Quality Improvement Project about Whitening of the Side Guard Plate
P32E座椅护板顶白质量改进项目的研究
9.
If the vehicle is equipped with manually adjusted bucket seats, the inboard or outboard seat track may be serviced separately.
如果车辆配备有手工调节斗式座椅，内侧或外侧座椅轨道可以分别使用。
10.
Separate the cover from the cushion.
从座椅垫移下座椅盖。
11.
The 3-year-old restraint was very poor in the frontal crash and failed to contain the head in side impact.
3岁儿童座椅固定在正面碰撞中非常差，侧面碰撞中儿童头部甩出了座椅。
12.
Design and Analysis of Curve-Plate on Non-Linear Seat-Suspension;
非线性座椅悬架曲面板设计及理论分析
13.
Install seat cushion outboard trim cover.
安装座位衬垫外侧饰板盖。
14.
Memory package for front seats, steering column and exterior mirrors (including parking position on front passenger side) for S 500 Long Wheelbase Version
S 500加长版轿车：前排座椅，转向柱和外部后视镜（包括前座乘客侧驻车位置）带有记忆组件
15.
Construction Techniques for Lateral Chock Block in CRTSⅡ Ballastless Track Bed Plate
CRTSⅡ型无砟轨道底座板侧向挡块施工技术
16.
The wind deflector integrated behind the rear headrests minimises wind intrusion.
后排座椅头枕中间的风向导流板大大减少了不必要的旋风和风噪。
17.
It is best suited to glazing and protection of household appliances, vehicles instrument panels, tires, leather seats, furniture and plastics.
最适于家用电器、辆仪表板、胎、革座椅、私、料制品的上光及保护。
18.
Pull rear seat bottom forward and fold down rear seat.
向前拉后座椅底部，并折叠后座椅。